On Wed, Nov 25, 2020 at 05:18:14PM +0100, Lukasz Majewski wrote:
> From: Mans Rullgard <mans@xxxxxxxxx>
>
> Add pinmux setting for USB1 overcurrent on pwm2 pad.
>
> Signed-off-by: Mans Rullgard <mans@xxxxxxxxx>
Lukasz,
You need to add your SoB.
Shawn
> ---
> arch/arm/boot/dts/imx28.dtsi | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/arch/arm/boot/dts/imx28.dtsi b/arch/arm/boot/dts/imx28.dtsi
> index 6e7531b64bf7..6d24546f0abe 100644
> --- a/arch/arm/boot/dts/imx28.dtsi
> +++ b/arch/arm/boot/dts/imx28.dtsi
> @@ -948,6 +948,16 @@
> fsl,pull-up = <MXS_PULL_DISABLE>;
> };
>
> + usb1_pins_b: usb1@1 {
> + reg = <1>;
> + fsl,pinmux-ids = <
> + MX28_PAD_PWM2__USB1_OVERCURRENT
> + >;
> + fsl,drive-strength = <MXS_DRIVE_12mA>;
> + fsl,voltage = <MXS_VOLTAGE_HIGH>;
> + fsl,pull-up = <MXS_PULL_DISABLE>;
> + };
> +
> usb0_id_pins_a: usb0id@0 {
> reg = <0>;
> fsl,pinmux-ids = <
> --
> 2.20.1
>
