Thank you for having a look at the patch!
On Fri, Nov 20, 2020 at 04:52:52PM +0100, Maxime Ripard wrote:
On Sun, Nov 15, 2020 at 11:24:25PM +0100, Michael Klein wrote:
Add gpio-line-names as documented in the Banana Pi wiki [1] and in the
schematics [2].
[1]: http://wiki.banana-pi.org/Banana_Pi_BPI-M2_ZERO#GPIO_PIN_define
[2]: https://drive.google.com/file/d/0B4PAo2nW2KfnMW5sVkxWSW9qa28/view
Signed-off-by: Michael Klein <michael@xxxxxxxxxxxx>
---
.../dts/sun8i-h2-plus-bananapi-m2-zero.dts | 64 +++++++++++++++++++
1 file changed, 64 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-h2-plus-bananapi-m2-zero.dts b/arch/arm/boot/dts/sun8i-h2-plus-bananapi-m2-zero.dts
index 4c6704e4c57e..b4ddfaf01b45 100644
--- a/arch/arm/boot/dts/sun8i-h2-plus-bananapi-m2-zero.dts
+++ b/arch/arm/boot/dts/sun8i-h2-plus-bananapi-m2-zero.dts
@@ -136,6 +136,70 @@ bluetooth {
};
+&pio {
+ gpio-line-names =
+ /* PA */
+ "UART2-TX", "UART2-RX", "UART2-RTS", "UART2-CTS",
+ "UART0-TXD", "UART0-RXD", "PWM1", "PA7-EINT7",
+ "PA8-EINT8", "PA9-EINT9", "PA10-EINT10", "TWI0-SCK",
+ "TWI0-SDA", "UART3-TX", "UART3-RX", "UART3-RTS",
+ "UART3-CTS", "PA17-EINT17", "TWI1-SCK", "TWI1-SDA",
+ "PA20-EINT20", "PA21-EINT21", "", "",
+ "", "", "", "", "", "", "", "",
IIRC, the point is to have the pin names that the vendor publishes.
Looking at Documentation/devicetree/bindings/gpio/gpio.txt, it says:
"""
Optionally, a GPIO controller may have a "gpio-line-names" property. This is
an array of strings defining the names of the GPIO lines going out of the
GPIO controller. This name should be the most meaningful producer name
for the system, such as a rail name indicating the usage. Package names
such as pin name are discouraged: such lines have opaque names (since they
are by definition generic purpose) and such names are usually not very
helpful.
"""
In this case, from the link you gave above, I think having the CON*-P*
names make more sense.
Hm, but these are the pin names (of the connector) and should thus not
be used, right?
For e.g. the PA0 pin, the wiki link gives three candidates:
- CON2-P13 (GPIO Pin Name -> pin 13 of the 40 pin GPIO header)
- UART2-TX (Default Function)
- PA0-EINT0 (Function2 : GPIO)
IMHO, the CON*-P* name is the least helpful of the above, as it tells
nothing about the usage. I'm not sure about the other two names, though.
Michael
