With board revision 1.3, SolidRun moved the power LED to the middle of
the board. In old place of power LED a GPIO controllable heartbeat LED
was added. This commit only touches Single Shot variant, since only this
variant is all revision 1.3.
Reported-by: Alexandra Alth <alexandra@xxxxxxx>
Signed-off-by: Tomasz Maciej Nowak <tmn505@xxxxxxxxx>
---
.../marvell/armada-8040-mcbin-singleshot.dts | 22 +++++++++++++++++++
1 file changed, 22 insertions(+)
diff --git a/arch/arm64/boot/dts/marvell/armada-8040-mcbin-singleshot.dts b/arch/arm64/boot/dts/marvell/armada-8040-mcbin-singleshot.dts
index 2e6832d02a59..411d20064271 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-mcbin-singleshot.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-mcbin-singleshot.dts
@@ -5,6 +5,8 @@
* Device Tree file for MACCHIATOBin Armada 8040 community board platform
*/
+#include <dt-bindings/leds/common.h>
+
#include "armada-8040-mcbin.dtsi"
/ {
@@ -12,6 +14,19 @@ / {
compatible = "marvell,armada8040-mcbin-singleshot",
"marvell,armada8040-mcbin", "marvell,armada8040",
"marvell,armada-ap806-quad", "marvell,armada-ap806";
+
+ leds {
+ compatible = "gpio-leds";
+ pinctrl-0 = <&cp0_led18_pins>;
+ pinctrl-names = "default";
+
+ led18 {
+ gpios = <&cp0_gpio2 1 GPIO_ACTIVE_LOW>;
+ function = LED_FUNCTION_HEARTBEAT;
+ color = <LED_COLOR_ID_GREEN>;
+ linux,default-trigger = "heartbeat";
+ };
+ };
};
&cp0_eth0 {
@@ -27,3 +42,10 @@ &cp1_eth0 {
managed = "in-band-status";
sfp = <&sfp_eth1>;
};
+
+&cp0_pinctrl {
+ cp0_led18_pins: led18-pins {
+ marvell,pins = "mpp33";
+ marvell,function = "gpio";
+ };
+};
--
2.29.2
