On 11/3/20 6:28 PM, Ben Dooks wrote: > EXTERNAL EMAIL: Do not click links or open attachments unless you know > the content is safe > > On 03/11/2020 18:10, Cyril.Jean@xxxxxxxxxxxxx wrote: >> On 11/3/20 3:07 PM, Atish Patra wrote: >>> EXTERNAL EMAIL: Do not click links or open attachments unless you >>> know the content is safe >>> >>> On Fri, Oct 30, 2020 at 2:20 PM Ben Dooks >>> <ben.dooks@xxxxxxxxxxxxxxx> wrote: > > ,snip[ > >>>>> @Cyril : Can we enable both eMMC & sdcard at the same time ? >>>> I would put /both/ in but only enable the one in use for the moment. >>>> Our boards are booting of eMMC as supplied, so this isn't going to >>>> work >>>> as well. The eMMC is 8bit wide, and thus is only delivering 11MB/sec >>>> instead of 22MB/sec. This performance is still not great, but losing >>>> half the data-rate is just not good. >>>> >>> I am not sure what should be enabled by default. Updating sdcard is >>> much >>> easier than eMMC card and we use that approach. >>> >>> @Cyril: Is there a way that we can enable both ? >>> >> Yes, we can enable both but this requires a modification to the FPGA >> design. One of the guys prototyped this while I was away. We will move >> this along. This will require reprogramming the FPGA with a new design >> and HSS version. >> >> Regards, >> >> Cyril. > > I either missed or couldn't find a way of forcing the boot mode to be > from the SD slot. Have I missed something? At the moment we'd like to > have more storage available as the ~7G free on the eMMC is not enough. > Currently, you need to program a different FPGA bitstream on the board to boot from SD-card. The different bitstream configures muxes on the board to connect the SD slot to the FPGA and the HSS included in the bit stream configures the FPGA IOs correctly. Links to the programming files are found in this document: https://github.com/polarfire-soc/polarfire-soc-documentation/blob/master/boards/mpfs-icicle-kit-es/updating-icicle-kit/updating-icicle-kit-design-and-linux.md Regards, Cyril.
