On Sun, Nov 01, 2020 at 10:35:01AM +0100, Christian Eggers wrote:
> Hi Vladimir,
>
> On Friday, 30 October 2020, 19:24:47 CET, Vladimir Oltean wrote:
> > On Thu, Oct 22, 2020 at 12:17:48PM +0200, Christian Eggers wrote:
> > > I tried to study the effect of setting the ocmode bit on the KSZ either to
> > > master or to slave. The main visible change is, that some PTP message
> > > types
> > > are be filtered out on RX:
> > > - in "master" mode, "Sync" messages from other nodes will not be received
> > > (but everything else like "Announce" seem to work)
> > > - in "slave" mode, "Delay_Req" messages from other nodes will not be
> > > received
> > Could you dump the contents of your REG_PTP_MSG_CONF2 register?
> runtime register value is 0x1004 (matches default value from the data sheet).
> The Linux driver doesn't touch this register. Below is a dump of all PTP
> related (global) registers.
So the bit 5 ("Enable Dropping of Sync/Follow_Up and Delay_Req PTP
Messages") is not set. When the PTP messages are dropped, do you know
which error counter in ethtool -S is increasing?
