Allow the mockup driver to be probed via the device tree without any
module parameters, allowing it to be used to configure and test higher
level drivers like the leds-gpio driver and corresponding userspace
before actual hardware is available.
Signed-off-by: Vincent Whitchurch <vincent.whitchurch@xxxxxxxx>
---
v2: Remove most of the added code, since the latest driver doesn't need it.
Drop DT binding document, since Rob Herring was OK with not documenting
this:
https://lore.kernel.org/linux-devicetree/5baa1ae6.1c69fb81.847f2.3ab1@xxxxxxxxxxxxx/
drivers/gpio/gpio-mockup.c | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/drivers/gpio/gpio-mockup.c b/drivers/gpio/gpio-mockup.c
index 67ed4f238d43..c93892a6936a 100644
--- a/drivers/gpio/gpio-mockup.c
+++ b/drivers/gpio/gpio-mockup.c
@@ -13,6 +13,7 @@
#include <linux/gpio/driver.h>
#include <linux/interrupt.h>
#include <linux/irq.h>
+#include <linux/of.h>
#include <linux/irq_sim.h>
#include <linux/irqdomain.h>
#include <linux/module.h>
@@ -460,9 +461,18 @@ static int gpio_mockup_probe(struct platform_device *pdev)
return 0;
}
+#ifdef CONFIG_OF
+static const struct of_device_id gpio_mockup_of_match[] = {
+ { .compatible = "gpio-mockup", },
+ {},
+};
+MODULE_DEVICE_TABLE(of, gpio_mockup_of_match);
+#endif
+
static struct platform_driver gpio_mockup_driver = {
.driver = {
.name = "gpio-mockup",
+ .of_match_table = of_match_ptr(gpio_mockup_of_match),
},
.probe = gpio_mockup_probe,
};
@@ -556,8 +566,7 @@ static int __init gpio_mockup_init(void)
{
int i, num_chips, err;
- if ((gpio_mockup_num_ranges < 2) ||
- (gpio_mockup_num_ranges % 2) ||
+ if ((gpio_mockup_num_ranges % 2) ||
(gpio_mockup_num_ranges > GPIO_MOCKUP_MAX_RANGES))
return -EINVAL;
--
2.28.0
