New nodes are enabled by default, so status=okay is not needed for them.
Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
Not actually tested on the HW, just checked the output DTB.
---
arch/arm/boot/dts/exynos4412-galaxy-s3.dtsi | 1 -
arch/arm/boot/dts/exynos4412-midas.dtsi | 3 ---
2 files changed, 4 deletions(-)
diff --git a/arch/arm/boot/dts/exynos4412-galaxy-s3.dtsi b/arch/arm/boot/dts/exynos4412-galaxy-s3.dtsi
index db91678f5648..64274b803aef 100644
--- a/arch/arm/boot/dts/exynos4412-galaxy-s3.dtsi
+++ b/arch/arm/boot/dts/exynos4412-galaxy-s3.dtsi
@@ -58,7 +58,6 @@ i2c_ak8975: i2c-gpio-0 {
i2c-gpio,delay-us = <2>;
#address-cells = <1>;
#size-cells = <0>;
- status = "okay";
magnetometer@c {
compatible = "asahi-kasei,ak8975";
diff --git a/arch/arm/boot/dts/exynos4412-midas.dtsi b/arch/arm/boot/dts/exynos4412-midas.dtsi
index 52a4f6e6c7f2..72f8d8040f77 100644
--- a/arch/arm/boot/dts/exynos4412-midas.dtsi
+++ b/arch/arm/boot/dts/exynos4412-midas.dtsi
@@ -169,7 +169,6 @@ i2c_max77693: i2c-gpio-1 {
i2c-gpio,delay-us = <2>;
#address-cells = <1>;
#size-cells = <0>;
- status = "okay";
max77693@66 {
compatible = "maxim,max77693";
@@ -218,7 +217,6 @@ i2c_max77693_fuel: i2c-gpio-3 {
i2c-gpio,delay-us = <2>;
#address-cells = <1>;
#size-cells = <0>;
- status = "okay";
fuel-gauge@36 {
compatible = "maxim,max17047";
@@ -262,7 +260,6 @@ i2c-mhl {
pinctrl-0 = <&i2c_mhl_bus>;
pinctrl-names = "default";
- status = "okay";
sii9234: hdmi-bridge@39 {
compatible = "sil,sii9234";
--
2.25.1
