Hi Richard, On Thursday, 22 October 2020, 04:42:01 CEST, Richard Cochran wrote: > I'm just catching up with this. > > Really. Truly. Please -- Include the maintainer on CC for such patches! sorry for missing you on the recipients list. I blindly trusted the output of get_maintainer.pl. I recently sent two other patches which may also be of interest for you. They related to handling of SO_TIMESTAMPING on 32 bit platforms with newer C libraries: https://patchwork.ozlabs.org/project/netdev/patch/20201012093542.15504-1-ceggers@xxxxxxx/ https://patchwork.ozlabs.org/project/netdev/patch/20201012093542.15504-2-ceggers@xxxxxxx/ > On Thu, Oct 22, 2020 at 02:39:35AM +0300, Vladimir Oltean wrote: > > On Mon, Oct 19, 2020 at 07:24:33PM +0200, Christian Eggers wrote: > > > The PTP hardware performs internal detection of PTP frames (likely > > > similar as ptp_classify_raw() and ptp_parse_header()). As these filters > > > cannot be disabled, the current delay mode (E2E/P2P) and the clock mode > > > (master/slave) must be configured via sysfs attributes. > > This is a complete no-go. NAK. I didn't design the hardware nor do I have access to adequate documentation. I will try to figure out what functionality is concretely affected by these two settings. If I am correct, the KSZ hardware consists of two main building blocks: 1. A TC on the switch path. 2. An OC on the DSA host port. >From the data sheet, page 109, chapter 5.1.6.11 ("Global PTP Message Config 1 Register"), bit 2: > *Selection of P2P or E2E* > 1 = Peer-to-peer (P2P) transparent clock mode > 0 = End-to-end (E2E) transparent clock mode So this "tcmode" sysfs entry controls the behavior of the switch' transparent clock. Is this related in any way to the PTP API? For the master/slave setting, the data sheet writes the following: *Selection of Master or Slave* 1 = Host port is PTP master ordinary clock 0 = Host port is PTP slave ordinary clock So this is really related to the OC and so to the PTP API. Setting this manually would interfere with the BMCA. I'll check whether delay measurement and clock synchronization can also work for all conditions (E2E/P2P, master/slave) without altering this value. Otherwise we might consider the KSZ as a "Slave Only Clock (SO)". Christian
