Hi everyone, this series aims at adding support to RPi's official PoE HAT fan[1]. The HW setup is the following: | Raspberry Pi | PoE HAT | arm core -> Mailbox -> RPi co-processor -> I2C -> Atmel MCU -> PWM -> FAN The arm cores have only access to the mailbox interface, as i2c0, even if physically accessible, is to be used solely by the co-processor (VideoCore 4/6). This series implements a PWM bus, and has pwm-fan sitting on top of it as per this discussion: https://lkml.org/lkml/2018/9/2/486. Although this design has a series of shortcomings: - It depends on a DT binding: it's not flexible if a new hat shows up with new functionality, we're not 100% sure we'll be able to expand it without breaking backwards compatibility. But without it we can't make use of DT thermal-zones, which IMO is overkill. - We're using pwm-fan, writing a hwmon driver would, again, give us more flexibility, but it's not really needed at the moment. I personally think that it's not worth the effort, it's unlikely we'll get things right in advance. And ultimately, if the RPi people come up with something new, we can always write a new driver/bindings from scratch (as in not reusing previous code). That said, I'm more than happy to change things if there is a consensus that another design will do the trick. [1] https://www.raspberrypi.org/blog/introducing-power-over-ethernet-poe-hat/ --- Nicolas Saenz Julienne (3): dt-bindings: pwm: Add binding for RPi firmware PWM bus DO NOT MERGE: ARM: dts: Add RPi's official PoE hat support pwm: Add Raspberry Pi Firmware based PWM bus .../arm/bcm/raspberrypi,bcm2835-firmware.yaml | 21 ++ arch/arm/boot/dts/bcm2711-rpi-4-b.dts | 54 +++++ drivers/pwm/Kconfig | 7 + drivers/pwm/Makefile | 1 + drivers/pwm/pwm-raspberrypi.c | 216 ++++++++++++++++++ .../pwm/raspberrypi,firmware-pwm.h | 13 ++ 6 files changed, 312 insertions(+) create mode 100644 drivers/pwm/pwm-raspberrypi.c create mode 100644 include/dt-bindings/pwm/raspberrypi,firmware-pwm.h -- 2.28.0
