On 09/10/2020 14.15, Vinod Koul wrote:
>>> If for any any reason subsequent txn is for different direction, I would
>>> expect that parameters are set again before prep_ calls
>>
>> But in DEV_TO_DEV?
>
> Do we support that :D
>
>> If we have two peripherals, both needs config:
>> p1_config and p2_config
>>
>> What and how would one use the single peripheral_config?
>
> Since the config is implementation specific, I do not think it limits.
> You may create
>
> struct peter_config {
> struct p1_config;
> struct p2_config;
> };
The use case is:
MEM -DMA-> P1 -DMA-> P2
or
P2 -DMA-> P1 -DMA-> MEM
or
MEM -DMA-> P2
or
P2 -DMA-> MEM
or
MEM -DMA-> P1 -DMA-> MEM
How would the DMA guess what it should do? How would the independent P1
and P2 would know how to set up the config?
>>
>> If only one of them needs config, then sure, the driver can pin-point
>> which one the single config might apply to.
>>
>> Or you chain the same type of peripheral and you would need different
>> config for tx and rx?
>>
>> - Péter
>>
>> Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
>> Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
>
- Péter
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
