On Thu, Oct 01, 2020 at 02:06:58PM +0200, Schrempf Frieder wrote: > From: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx> > > Kontron Electronics GmbH offers small and powerful SoMs based on the > i.MX8M Mini SoC including PMIC, LPDDR4-RAM, eMMC and SPI NOR. > > The matching baseboards have the same form factor and similar interfaces > as the other boards from the Kontron "Board-Line" family, including > SD card, 1G Ethernet, 100M Ethernet, USB Host/OTG, digital IOs, RS232, > RS485, CAN, LVDS or HDMI, RTC and much more. > > Signed-off-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx> > --- > Changes for v3: > * Remove needless status properties > * Remove needless regulator properties for reg_vdd_5v > * Use proper PHY reset properties in PHY node > * Use phy-connection-type instead of phy-mode > * Adjust PMIC node name and label > * Add over-current-active-low to usbotg1 node > * Remove redundant bus-width property from usdhc2 node > * Remove needless regulator-compatible from reg_vdd_snvs > * Set minimum voltage to 85mV for reg_vdd_snvs > > Changes for v2: > * Make the licensing less strict (GPL-2.0+ OR MIT) > * Merge the SoM and baseboard DTs for N8010 and N8011 into one as > they only differ in DDR and eMMC size. > * Change compatibles and model strings to "n810x" and "N8010X". > * Only use a common memory node that will be updated by the > bootloader reflecting the detected DDR size. > * Improve naming for 16MHz CAN fixed oscillator and set > "clock-output-names". > * Consistently use "reg_" prefix for regulators. > * Remove "userspi" node. > * Slightly improve commit message. > --- > .../dts/freescale/imx8mm-kontron-n801x-s.dts | 323 ++++++++++++++++++ > .../freescale/imx8mm-kontron-n801x-som.dtsi | 293 ++++++++++++++++ > 2 files changed, 616 insertions(+) > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-s.dts > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi Ah, and one more issue - missing Makefile entry? This won't build. Best regards, Krzysztof
