As talked about in the patch ("arm64: dts: qcom: sc7180: Provide
pinconf for SPI to use GPIO for CS"), on some boards it makes much
more sense (and is much more efficient) to think of the SPI Chip
Select as a GPIO. Trogdor is one such board where the SPI parts don't
run in GSI mode and we do a lot of SPI traffic.
Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
---
(no changes since v1)
arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi | 19 ++++++++++++++++---
1 file changed, 16 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
index bf875589d364..0759896a0df5 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
@@ -776,7 +776,20 @@ &sdhc_2 {
cd-gpios = <&tlmm 69 GPIO_ACTIVE_LOW>;
};
+&spi0 {
+ pinctrl-0 = <&qup_spi0_cs_gpio>;
+ cs-gpios = <&tlmm 37 GPIO_ACTIVE_LOW>;
+};
+
+&spi6 {
+ pinctrl-0 = <&qup_spi6_cs_gpio>;
+ cs-gpios = <&tlmm 62 GPIO_ACTIVE_LOW>;
+};
+
ap_spi_fp: &spi10 {
+ pinctrl-0 = <&qup_spi10_cs_gpio>;
+ cs-gpios = <&tlmm 89 GPIO_ACTIVE_LOW>;
+
cros_ec_fp: ec@0 {
compatible = "google,cros-ec-spi";
reg = <0>;
@@ -937,7 +950,7 @@ pinconf {
};
};
-&qup_spi0_default {
+&qup_spi0_cs_gpio {
pinconf {
pins = "gpio34", "gpio35", "gpio36", "gpio37";
drive-strength = <2>;
@@ -945,7 +958,7 @@ pinconf {
};
};
-&qup_spi6_default {
+&qup_spi6_cs_gpio {
pinconf {
pins = "gpio59", "gpio60", "gpio61", "gpio62";
drive-strength = <2>;
@@ -953,7 +966,7 @@ pinconf {
};
};
-&qup_spi10_default {
+&qup_spi10_cs_gpio {
pinconf {
pins = "gpio86", "gpio87", "gpio88", "gpio89";
drive-strength = <2>;
--
2.28.0.681.g6f77f65b4e-goog
