Hi, On Thu, Sep 10, 2020 at 5:55 AM satya priya <skakit@xxxxxxxxxxxxxx> wrote: > > Add a suitable sleep configuration for uart3 to support Bluetooth wakeup. > > If QUP function is selected in sleep state, UART RTS/RFR is pulled high > during suspend and BT SoC not able to send wakeup bytes. So, configure > GPIO mode in sleep state to keep it low during suspend. > > Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx> > --- > Changes in V5: > - Newly added in V5. This patch adds wakeup support for trogdor board files. > > arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi | 48 ++++++++++++++++++++++++++++ > 1 file changed, 48 insertions(+) Note: I can't find this email on any of the mailing lists. Can you check your config? I tried: http://lore.kernel.org/r/1599742438-16811-4-git-send-email-skakit@xxxxxxxxxxxxxx ...and also checked patchwork servers. I only see patch 1 and 2. I think Bjorn usually applies from patchwork so this'll likely be a problem... > diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi > index a6b9beb..96b5331 100644 > --- a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi > +++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi > @@ -792,6 +792,11 @@ ap_spi_fp: &spi10 { > #include <arm/cros-ec-sbs.dtsi> > > &uart3 { > + pinctrl-names = "default", "sleep"; > + pinctrl-1 = <&qup_uart3_sleep>; > + interrupts-extended = <&intc GIC_SPI 604 IRQ_TYPE_LEVEL_HIGH>, > + <&tlmm 41 IRQ_TYPE_EDGE_FALLING>; > + > status = "okay"; Same comments here as for patch #2. > bluetooth: bluetooth { > @@ -1345,4 +1350,47 @@ ap_spi_fp: &spi10 { > drive-strength = <2>; > }; > }; > + > + qup_uart3_sleep: qup-uart3-sleep { I believe things in this section are supposed to be sorted alphabetically. Thus "qup..." should be sorted before "trackpad..."
