GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW = 1 = IRQ_TYPE_EDGE_RISING
Correct the interrupt flags, assuming the author of the code wanted some
logical behavior behind the name "ACTIVE_xxx", this is:
ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW
Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
Not tested on HW.
---
arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts | 2 +-
arch/arm64/boot/dts/freescale/imx8mn-evk.dts | 3 ++-
2 files changed, 3 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts b/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
index a1e5483dbbbe..9e12b5234692 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
@@ -55,7 +55,7 @@
reg = <0x4b>;
pinctrl-0 = <&pinctrl_pmic>;
interrupt-parent = <&gpio1>;
- interrupts = <3 GPIO_ACTIVE_LOW>;
+ interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
rohm,reset-snvs-powered;
regulators {
diff --git a/arch/arm64/boot/dts/freescale/imx8mn-evk.dts b/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
index b846526a8d8b..707d8486b4d8 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
@@ -7,6 +7,7 @@
#include "imx8mn.dtsi"
#include "imx8mn-evk.dtsi"
+#include <dt-bindings/interrupt-controller/irq.h>
/ {
model = "NXP i.MX8MNano EVK board";
@@ -19,7 +20,7 @@
reg = <0x25>;
pinctrl-0 = <&pinctrl_pmic>;
interrupt-parent = <&gpio1>;
- interrupts = <3 GPIO_ACTIVE_LOW>;
+ interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
regulators {
buck1: BUCK1{
--
2.17.1
