Using full paths to extend or override a device tree node is error prone
since if there was a typo error, a new node will be created instead of
extending the node as it was desired. This will lead to run-time errors
that could be hard to detect.
A mistyped label on the other hand, will cause a dtc compile error
(during build time).
Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
arch/arm/boot/dts/exynos5250.dtsi | 38 +++++++++++++++----------------
1 file changed, 18 insertions(+), 20 deletions(-)
diff --git a/arch/arm/boot/dts/exynos5250.dtsi b/arch/arm/boot/dts/exynos5250.dtsi
index 0249d16e187f..488d3f9fab59 100644
--- a/arch/arm/boot/dts/exynos5250.dtsi
+++ b/arch/arm/boot/dts/exynos5250.dtsi
@@ -1085,26 +1085,6 @@
};
};
- thermal-zones {
- cpu_thermal: cpu-thermal {
- polling-delay-passive = <0>;
- polling-delay = <0>;
- thermal-sensors = <&tmu 0>;
-
- cooling-maps {
- map0 {
- /* Corresponds to 800MHz at freq_table */
- cooling-device = <&cpu0 9 9>, <&cpu1 9 9>;
- };
- map1 {
- /* Corresponds to 200MHz at freq_table */
- cooling-device = <&cpu0 15 15>,
- <&cpu1 15 15>;
- };
- };
- };
- };
-
timer {
compatible = "arm,armv7-timer";
interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
@@ -1120,6 +1100,24 @@
};
};
+&cpu_thermal {
+ polling-delay-passive = <0>;
+ polling-delay = <0>;
+ thermal-sensors = <&tmu 0>;
+
+ cooling-maps {
+ map0 {
+ /* Corresponds to 800MHz at freq_table */
+ cooling-device = <&cpu0 9 9>, <&cpu1 9 9>;
+ };
+ map1 {
+ /* Corresponds to 200MHz at freq_table */
+ cooling-device = <&cpu0 15 15>,
+ <&cpu1 15 15>;
+ };
+ };
+};
+
&dp {
power-domains = <&pd_disp1>;
clocks = <&clock CLK_DP>;
--
2.17.1
