Fix the leds subnode names to match (^led-[0-9a-f]$|led).
Similar change has been also done by commit 08dc0e5dd9aa ("arm64: dts:
meson: fix leds subnodes name").
The patch is fixing this warning:
avnet-ultra96-rev1.dt.yaml: leds: 'ds2', 'ds3', 'ds4', 'ds5' do not match
any of the regexes: '(^led-[0-9a-f]$|led)', 'pinctrl-[0-9]+'
Signed-off-by: Michal Simek <michal.simek@xxxxxxxxxx>
---
vbus-det led is not fixed because it is not LED. It should be likely
handled as gpio hog.
---
arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
index d60110ad8367..2352dc553ba7 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
+++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
@@ -56,27 +56,27 @@ sw4 {
leds {
compatible = "gpio-leds";
- ds2 {
+ led-ds2 {
label = "ds2";
gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "heartbeat";
};
- ds3 {
+ led-ds3 {
label = "ds3";
gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy0tx"; /* WLAN tx */
default-state = "off";
};
- ds4 {
+ led-ds4 {
label = "ds4";
gpios = <&gpio 18 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy0rx"; /* WLAN rx */
default-state = "off";
};
- ds5 {
+ led-ds5 {
label = "ds5";
gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "bluetooth-power";
--
2.28.0
