On Sun, Jul 19, 2020 at 03:22:22PM -0700, Guenter Roeck wrote: > On Fri, Jul 10, 2020 at 12:42:58AM +0000, Chu Lin wrote: > > Problem: > > adm1272 and adm1278 supports temperature sampling. The > > current way of enabling it requires the user manually unbind the device > > from the driver, flip the temperature sampling control bit and then bind > > the device back to the driver. It would be nice if we can control this in a > > better way by reading the dt. > > > > Solution: > > Introducing device tree binding adm1272-adm1278-temp1-en. If the > > flag is set, flip the temp1_en control bit on probing. > > > > Testing: > > make dt_binding_check > > > > Signed-off-by: Chu Lin <linchuyuan@xxxxxxxxxx> > > --- > > Documentation/devicetree/bindings/hwmon/adm1275.txt | 3 +++ > > 1 file changed, 3 insertions(+) > > > > diff --git a/Documentation/devicetree/bindings/hwmon/adm1275.txt b/Documentation/devicetree/bindings/hwmon/adm1275.txt > > index 1ecd03f3da4d..4403fe30f005 100644 > > --- a/Documentation/devicetree/bindings/hwmon/adm1275.txt > > +++ b/Documentation/devicetree/bindings/hwmon/adm1275.txt > > @@ -15,6 +15,8 @@ Optional properties: > > > > - shunt-resistor-micro-ohms > > Shunt resistor value in micro-Ohm > > +- adm1272-adm1278-temp1-en > > + Enable temperature sampling. This is supported on adm1272 and adm1278 > > I suspect this should be something like "analog,temp1-enable". Yes. > Either case, > I would suggest to resend the series and copy DT maintainers at least on > this patch. Only the DT list matters. Rob
