Re: [RFC PATCH v3 16/18] gpu: host1x: mipi: Split tegra_mipi_calibrate and tegra_mipi_wait

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 7/16/20 4:01 PM, Dmitry Osipenko wrote:
17.07.2020 01:49, Sowjanya Komatineni пишет:
What keeps MIPI clock enabled after completion of the
tegra_mipi_calibrate() invocation?
MIPI clock is disabled at end of tegra_mipi_calibrate and is re-enabled
during tegra_mipi_wait.

I think I should fix this to keep the clock enabled till calibration
results are latched.

All consumers of tegra_mipi_calibrate() will call tegra_mipi_wait().

So will remove clk_disable mipi clk at end of tegra_mipi_calibrate() and
clk_enable mipi_clk at beginning of tegra_mipi_wait()
Isn't it possible to perform the calibration after enabling CSI and
before of starting the sensor streaming?
Currently this is what I am doing. Triggering calibration start during CSI receiver being ready and then sensor streaming will happen where internal MIPI CAL detects for LP -> HS transition and applies results to pads. So checking for calibration results after sensor stream is enabled




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux