This patch documents missing clocks and power-domains of Tegra210 VI I2C. Reviewed-by: Rob Herring <robh@xxxxxxxxxx> Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx> --- .../devicetree/bindings/i2c/nvidia,tegra20-i2c.txt | 19 +++++++++++++------ 1 file changed, 13 insertions(+), 6 deletions(-) diff --git a/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt b/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt index 18c0de3..3f2f990 100644 --- a/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt +++ b/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt @@ -35,12 +35,12 @@ Required properties: Due to above changes, Tegra114 I2C driver makes incompatible with previous hardware driver. Hence, tegra114 I2C controller is compatible with "nvidia,tegra114-i2c". - nvidia,tegra210-i2c-vi: Tegra210 has one I2C controller that is part of the - host1x domain and typically used for camera use-cases. This VI I2C - controller is mostly compatible with the programming model of the - regular I2C controllers with a few exceptions. The I2C registers start - at an offset of 0xc00 (instead of 0), registers are 16 bytes apart - (rather than 4) and the controller does not support slave mode. + nvidia,tegra210-i2c-vi: Tegra210 has one I2C controller that is on host1x bus + and is part of VE power domain and typically used for camera use-cases. + This VI I2C controller is mostly compatible with the programming model + of the regular I2C controllers with a few exceptions. The I2C registers + start at an offset of 0xc00 (instead of 0), registers are 16 bytes + apart (rather than 4) and the controller does not support slave mode. - reg: Should contain I2C controller registers physical address and length. - interrupts: Should contain I2C controller interrupts. - address-cells: Address cells for I2C device address. @@ -53,10 +53,17 @@ Required properties: - fast-clk Tegra114: - div-clk + Tegra210: + - div-clk + - slow (only for nvidia,tegra210-i2c-vi compatible node) - resets: Must contain an entry for each entry in reset-names. See ../reset/reset.txt for details. - reset-names: Must include the following entries: - i2c +- power-domains: Only for nvidia,tegra210-i2c-vi compatible node and must + include venc powergate node as vi i2c is part of VE power domain. + tegra210-i2c-vi: + - pd_venc - dmas: Must contain an entry for each entry in clock-names. See ../dma/dma.txt for details. - dma-names: Must include the following entries: -- 2.7.4
