This device hierarchy is needlessly complex. Remove the support-card node level, and move the ethernet and serial nodes right under the system-bus node. This also fixes the following warning from 'make ARCH=arm dtbs_check': support-card@1,1f00000: $nodename:0: 'support-card@1,1f00000' does not match '^(bus|soc|axi|ahb|apb)(@[0-9a-f]+)?$' Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> --- arch/arm/boot/dts/uniphier-support-card.dtsi | 31 ++++++++------------ 1 file changed, 12 insertions(+), 19 deletions(-) diff --git a/arch/arm/boot/dts/uniphier-support-card.dtsi b/arch/arm/boot/dts/uniphier-support-card.dtsi index 11e46e7de7c5..444802fee9fb 100644 --- a/arch/arm/boot/dts/uniphier-support-card.dtsi +++ b/arch/arm/boot/dts/uniphier-support-card.dtsi @@ -8,26 +8,19 @@ &system_bus { status = "okay"; ranges = <1 0x00000000 0x42000000 0x02000000>; + interrupt-parent = <&gpio>; - support_card: support-card@1,1f00000 { - compatible = "simple-bus"; - #address-cells = <1>; - #size-cells = <1>; - ranges = <0x00000000 1 0x01f00000 0x00100000>; - interrupt-parent = <&gpio>; - - ethsc: ethernet@0 { - compatible = "smsc,lan9118", "smsc,lan9115"; - reg = <0x00000000 0x1000>; - phy-mode = "mii"; - reg-io-width = <4>; - }; + ethsc: ethernet@1,1f00000 { + compatible = "smsc,lan9118", "smsc,lan9115"; + reg = <1 0x01f00000 0x1000>; + phy-mode = "mii"; + reg-io-width = <4>; + }; - serialsc: serial@b0000 { - compatible = "ns16550a"; - reg = <0x000b0000 0x20>; - clock-frequency = <12288000>; - reg-shift = <1>; - }; + serialsc: serial@1,1fb0000 { + compatible = "ns16550a"; + reg = <1 0x01fb0000 0x20>; + clock-frequency = <12288000>; + reg-shift = <1>; }; }; -- 2.25.1