[PATCH v2 2/2] ARM: dts: stm32: Enable MIPI DSI display support.

[Adrian Pop <pop.adrian61@xxxxxxxxx>]

STM32f769-disco features a 4" MIPI DSI display: add support for it.
On Cortex-M7 DMA can't use cached memory. For this reason I use a dedicated
memory pool for DMA with no-cache attribute which is located at the end of
 RAM.

Signed-off-by: Adrian Pop <pop.adrian61@xxxxxxxxx>
---
 arch/arm/boot/dts/stm32f746.dtsi      | 34 +++++++++++++++++++
 arch/arm/boot/dts/stm32f769-disco.dts | 49 +++++++++++++++++++++++++++
 2 files changed, 83 insertions(+)

diff --git a/arch/arm/boot/dts/stm32f746.dtsi b/arch/arm/boot/dts/stm32f746.dtsi
index 93c063796780..577a812ca01c 100644
--- a/arch/arm/boot/dts/stm32f746.dtsi
+++ b/arch/arm/boot/dts/stm32f746.dtsi
@@ -48,6 +48,19 @@ / {
 	#address-cells = <1>;
 	#size-cells = <1>;
 
+	reserved-memory {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		ranges;
+
+		linux,dma {
+			compatible = "shared-dma-pool";
+			linux,dma-default;
+			no-map;
+			reg = <0xc0f00000 0x100000>;
+		};
+	};
+
 	clocks {
 		clk_hse: clk-hse {
 			#clock-cells = <0>;
@@ -75,6 +88,27 @@ clk_i2s_ckin: clk-i2s-ckin {
 	};
 
 	soc {
+		ltdc: display-controller@40016800 {
+			compatible = "st,stm32-ltdc";
+			reg = <0x40016800 0x200>;
+			interrupts = <88>, <89>;
+			resets = <&rcc STM32F7_APB2_RESET(LTDC)>;
+			clocks = <&rcc 1 CLK_LCD>;
+			clock-names = "lcd";
+			status = "disabled";
+		};
+
+		dsi: dsi@40016c00 {
+			compatible = "st,stm32-dsi";
+			reg = <0x40016c00 0x800>;
+			interrupts = <98>;
+			clocks = <&rcc 1 CLK_F769_DSI>, <&clk_hse>;
+			clock-names = "pclk", "ref";
+			resets = <&rcc STM32F7_APB2_RESET(DSI)>;
+			reset-names = "apb";
+			status = "disabled";
+		};
+
 		timer2: timer@40000000 {
 			compatible = "st,stm32-timer";
 			reg = <0x40000000 0x400>;
diff --git a/arch/arm/boot/dts/stm32f769-disco.dts b/arch/arm/boot/dts/stm32f769-disco.dts
index 1626e00bb2cb..a9e81b49809c 100644
--- a/arch/arm/boot/dts/stm32f769-disco.dts
+++ b/arch/arm/boot/dts/stm32f769-disco.dts
@@ -153,3 +153,52 @@ &usbotg_hs {
 	pinctrl-names = "default";
 	status = "okay";
 };
+
+&dsi {
+	#address-cells = <1>;
+	#size-cells = <0>;
+	status = "okay";
+
+	ports {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		port@0 {
+			reg = <0>;
+			dsi_in: endpoint {
+				remote-endpoint = <&ltdc_out_dsi>;
+			};
+		};
+
+		port@1 {
+			reg = <1>;
+			dsi_out: endpoint {
+				remote-endpoint = <&dsi_in_panel>;
+			};
+		};
+
+	};
+
+	panel: panel {
+		compatible = "orisetech,otm8009a";
+		reg = <0>;
+		reset-gpios = <&gpioj 15 GPIO_ACTIVE_LOW>;
+		status = "okay";
+
+		port {
+			dsi_in_panel: endpoint {
+				remote-endpoint = <&dsi_out>;
+			};
+		};
+	};
+};
+
+&ltdc {
+	status = "okay";
+
+	port {
+		ltdc_out_dsi: endpoint {
+			remote-endpoint = <&dsi_in>;
+		};
+	};
+};
-- 
2.27.0