On Mon, Jun 15, 2020 at 5:08 PM Alexandre Torgue <alexandre.torgue@xxxxxx> wrote: > > Hi Dillon > > On 6/9/20 3:26 PM, dillon.minfei@xxxxxxxxx wrote: > > From: dillon min <dillon.minfei@xxxxxxxxx> > > > > This patchset is intend to enable stmpe811 touch screen on stm32f429-disco > > board with three dts and one i2c driver changes. > > > > has been validated by ts_print tool > > > > Changes log: > > V4: indroduce 'IIC_LAST_BYTE_POS' to compatible with xipkernel boot > > > > V3: just add change log in [PATCH V3 3/4] below --- > > > > V2: remove id, blocks, irq-trigger from stmpe811 dts > > > > V1: > > ARM: dts: stm32: add I2C3 support on STM32F429 SoC > > ARM: dts: stm32: Add pin map for I2C3 controller on stm32f4 > > ARM: dts: stm32: enable stmpe811 on stm32429-disco board > > i2c: stm32f4: Fix stmpe811 get xyz data timeout issue > > > > dillon min (4): > > ARM: dts: stm32: add I2C3 support on STM32F429 SoC > > ARM: dts: stm32: Add pin map for I2C3 controller on stm32f4 > > ARM: dts: stm32: enable stmpe811 on stm32429-disco board > > i2c: stm32f4: Fix stmpe811 get xyz data timeout issue > > > > arch/arm/boot/dts/stm32f4-pinctrl.dtsi | 12 +++++++++ > > arch/arm/boot/dts/stm32f429-disco.dts | 47 ++++++++++++++++++++++++++++++++++ > > arch/arm/boot/dts/stm32f429.dtsi | 12 +++++++++ > > drivers/i2c/busses/i2c-stm32f4.c | 12 ++++++--- > > 4 files changed, 80 insertions(+), 3 deletions(-) > > > > DT patches applied on stm32-next. I changed node ordering in patch 3. Okay, thanks. Regards, Dillon, > > Thanks > Alex