Hi Krzysztof,
On Mon, May 26, 2014 at 6:50 PM, Krzysztof Kozlowski
<k.kozlowski@xxxxxxxxxxx> wrote:
> Prepare for merging the s2mpa01 regulator driver into s2mps11 by:
> 1. Adding common id for buck regulators.
> 2. Splitting shared ramp delay settings to match S2MPA01.
> 3. Adding a configuration of registers for setting ramp delay for each
> buck regulator.
>
> The functionality of the driver should not change as this patch only
> prepares for supporting S2MPA01 device.
>
> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
> ---
> drivers/regulator/s2mps11.c | 210 ++++++++++++++++++++++++++++++--------------
> 1 file changed, 144 insertions(+), 66 deletions(-)
>
[snip]
>
> - if (ramp_delay > s2mps11->ramp_delay34)
> - s2mps11->ramp_delay34 = ramp_delay;
> + if (ramp_delay > s2mps11->ramp_delay3)
> + s2mps11->ramp_delay3 = ramp_delay;
> else
> - ramp_delay = s2mps11->ramp_delay34;
> -
> - ramp_shift = S2MPS11_BUCK34_RAMP_SHIFT;
> - ramp_reg = S2MPS11_REG_RAMP;
> + ramp_delay = s2mps11->ramp_delay3;
> break;
> case S2MPS11_BUCK4:
> - enable_shift = S2MPS11_BUCK4_RAMP_EN_SHIFT;
> if (!ramp_delay) {
> ramp_enable = 0;
> break;
> }
>
> - if (ramp_delay > s2mps11->ramp_delay34)
> - s2mps11->ramp_delay34 = ramp_delay;
> + if (ramp_delay > s2mps11->ramp_delay4)
> + s2mps11->ramp_delay4 = ramp_delay;
> else
> - ramp_delay = s2mps11->ramp_delay34;
> -
> - ramp_shift = S2MPS11_BUCK34_RAMP_SHIFT;
> - ramp_reg = S2MPS11_REG_RAMP;
> + ramp_delay = s2mps11->ramp_delay4;
Main rationale behind shared value is completely omitted here, in
other cases also,
after just giving a NOTE in documentation asking user to make sure to
pass same value.
It doesn't seem safe, simply leaving a scope of stability issue (in
case ramp_delay3 > ramp_delay4).
Regards,
Yadwinder
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
