Re: [PATCH v5 03/14] PCI: cadence: Convert all r/w accessors to perform only 32-bit accesses

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Rob,

On 6/1/2020 6:46 AM, Kishon Vijay Abraham I wrote:
> Hi Rob,
> 
> On 5/28/2020 3:36 AM, Kishon Vijay Abraham I wrote:
>> Hi Rob,
>>
>> On 5/27/2020 10:07 PM, Rob Herring wrote:
>>> On Wed, May 27, 2020 at 4:49 AM Kishon Vijay Abraham I <kishon@xxxxxx> wrote:
>>>>
>>>> Hi Rob,
>>>>
>>>> On 5/26/2020 8:42 PM, Rob Herring wrote:
>>>>> On Sun, May 24, 2020 at 9:30 PM Kishon Vijay Abraham I <kishon@xxxxxx> wrote:
>>>>>>
>>>>>> Hi Rob,
>>>>>>
>>>>>> On 5/22/2020 9:24 PM, Rob Herring wrote:
>>>>>>> On Thu, May 21, 2020 at 9:37 PM Kishon Vijay Abraham I <kishon@xxxxxx> wrote:
>>>>>>>>
>>>>>>>> Certain platforms like TI's J721E using Cadence PCIe IP can perform only
>>>>>>>> 32-bit accesses for reading or writing to Cadence registers. Convert all
>>>>>>>> read and write accesses to 32-bit in Cadence PCIe driver in preparation
>>>>>>>> for adding PCIe support in TI's J721E SoC.
>>>>>>>
>>>>>>> Looking more closely I don't think cdns_pcie_ep_assert_intx is okay
>>>>>>> with this and never can be given the PCI_COMMAND and PCI_STATUS
>>>>>>> registers are in the same word (IIRC, that's the main reason 32-bit
>>>>>>> config space accesses are broken). So this isn't going to work at
>>>>>>
>>>>>> right, PCI_STATUS has write '1' to clear bits and there's a chance that it
>>>>>> could be reset while raising legacy interrupt. While this cannot be avoided for
>>>>>> TI's J721E, other platforms doesn't have to have this limitation.
>>>>>>> least for EP accesses. And maybe you need a custom .raise_irq() hook
>>>>>>> to minimize any problems (such as making the RMW atomic at least from
>>>>>>> the endpoint's perspective).
>>>>>>
>>>>>> This is to make sure EP doesn't update in-consistent state when RC is updating
>>>>>> the PCI_STATUS register? Since this involves two different systems, how do we
>>>>>> make this atomic?
>>>>>
>>>>> You can't make it atomic WRT both systems, but is there locking around
>>>>> each RMW? Specifically, are preemption and interrupts disabled to
>>>>> ensure time between a read and write are minimized? You wouldn't want
>>>>> interrupts disabled during the delay too though (i.e. around
>>>>> .raise_irq()).
>>>>
>>>> Okay, I'll add spin spin_lock_irqsave() in cdns_pcie_write_sz(). As you also
>>>> pointed below that delay for legacy interrupt is wrong and it has to be fixed
>>>> (with a later series).
>>>
>>> But you don't need a lock everywhere. You need locks in the callers
>>> (and only sometimes).
>>
>> Okay, the locks should be added only for registers where HOST can also write to
>> the same register? Maybe only raise_irq then..
>>
>>>
>>>> How do you want to handle cdns_pcie_ep_fn_writew() now? Because now we are
>>>> changing the default implementation to perform only 32-bit access (used for
>>>> legacy interrupt, msi-x interrupt and while writing standard headers) and it's
>>>> not okay only for legacy interrupts for platforms other than TI.
>>>
>>> Now I'm wondering how set_msi is not racy in the current code with the
>>> host setting/clearing PCI_MSI_FLAGS_ENABLE? Maybe that bit is RO from
>>> the EP side?
>>
>> set_msi/set_msix is a one time configuration that is invoked before the host
>> establishes the link with the endpoint. I don't think we have to consider this
>> as racy.
> 
> Can we try to close on this discussion please?

Should we just try to handle .raise_irq() separately for TI platform and all
the other accesses remain as 32-bit access?

Thanks
Kishon

> 
> Thanks
> Kishon
> 
>>
>> Thanks
>> Kishon
>>
>>>
>>> Ultimately I think you're going to have to provide your own endpoint
>>> functions or you need accessors for specific registers like
>>> PCI_MSI_FLAGS. Then for example, you just rely on the 2 bytes before
>>> PCI_MSI_FLAGS being reserved and do a 32-bit access without a RMW.
>>> Trying to abstract this at the register read/write level is going to
>>> be fragile
>>>
>>> Rob
>>>



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux