Re: [PATCH v2] spi: bcm2835: Enable shared interrupt support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Florian,
Thanks for taking over this!

On Thu, 2020-06-04 at 14:28 -0700, Florian Fainelli wrote:
> The 4 SPI controller instances added in BCM2711 and BCM7211 SoCs (SPI3,
> SPI4, SPI5 and SPI6) share the same interrupt line with SPI0.

I think this isn't 100% correct. SPI0 has its own interrupt, but SPI[3-6] share
the same interrupt.

> For the BCM2835 case which is deemed performance critical, we would like
> to continue using an interrupt handler which does not have the extra
> comparison on BCM2835_SPI_CS_INTR.
> 
> To support that requirement the common interrupt handling code between
> the shared and non-shared interrupt paths is split into a
> bcm2835_spi_interrupt_common() and both bcm2835_spi_interrupt() as well
> as bcm2835_spi_shared_interrupt() make use of it.
> 
> During probe, we determine if there is at least another instance of this
> SPI controller, and if there is, then we install a shared interrupt
> handler.

As there was pushback to use a different compatible string for an otherwise
identical IP, I think it's a good compromise.

> 
> Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
> ---
> Changes in v2:
> 
> - identify other available SPI nodes to determine if we need to set-up
>   interrupt sharing. This needs to happen for the very first instance
>   since we cannot know for the first instance whether interrupt sharing
>   is needed or not.
> 
>  drivers/spi/spi-bcm2835.c | 61 ++++++++++++++++++++++++++++++++-------
>  1 file changed, 50 insertions(+), 11 deletions(-)
> 
> diff --git a/drivers/spi/spi-bcm2835.c b/drivers/spi/spi-bcm2835.c
> index 237bd306c268..0288b5b3de1e 100644
> --- a/drivers/spi/spi-bcm2835.c
> +++ b/drivers/spi/spi-bcm2835.c
> @@ -361,11 +361,10 @@ static void bcm2835_spi_reset_hw(struct spi_controller
> *ctlr)
>  	bcm2835_wr(bs, BCM2835_SPI_DLEN, 0);
>  }
>  
> -static irqreturn_t bcm2835_spi_interrupt(int irq, void *dev_id)
> +static inline irqreturn_t bcm2835_spi_interrupt_common(struct spi_controller
> *ctlr,
> +						       u32 cs)

Keep in mind the new 100 character limit.

>  {
> -	struct spi_controller *ctlr = dev_id;
>  	struct bcm2835_spi *bs = spi_controller_get_devdata(ctlr);
> -	u32 cs = bcm2835_rd(bs, BCM2835_SPI_CS);
>  
>  	/*
>  	 * An interrupt is signaled either if DONE is set (TX FIFO empty)
> @@ -394,6 +393,27 @@ static irqreturn_t bcm2835_spi_interrupt(int irq, void
> *dev_id)
>  	return IRQ_HANDLED;
>  }
>  
> +static irqreturn_t bcm2835_spi_interrupt(int irq, void *dev_id)
> +{
> +	struct spi_controller *ctlr = dev_id;
> +	struct bcm2835_spi *bs = spi_controller_get_devdata(ctlr);
> +	u32 cs = bcm2835_rd(bs, BCM2835_SPI_CS);
> +
> +	return bcm2835_spi_interrupt_common(ctlr, cs);
> +}
> +
> +static irqreturn_t bcm2835_spi_shared_interrupt(int irq, void *dev_id)
> +{
> +	struct spi_controller *ctlr = dev_id;
> +	struct bcm2835_spi *bs = spi_controller_get_devdata(ctlr);
> +	u32 cs = bcm2835_rd(bs, BCM2835_SPI_CS);
> +
> +	if (!(cs & BCM2835_SPI_CS_INTR))
> +		return IRQ_NONE;
> +
> +	return bcm2835_spi_interrupt_common(ctlr, cs);
> +}
> +
>  static int bcm2835_spi_transfer_one_irq(struct spi_controller *ctlr,
>  					struct spi_device *spi,
>  					struct spi_transfer *tfr,
> @@ -1287,12 +1307,37 @@ static int bcm2835_spi_setup(struct spi_device *spi)
>  	return 0;
>  }
>  
> +static const struct of_device_id bcm2835_spi_match[] = {
> +	{ .compatible = "brcm,bcm2835-spi", },
> +	{}
> +};
> +MODULE_DEVICE_TABLE(of, bcm2835_spi_match);
> +
>  static int bcm2835_spi_probe(struct platform_device *pdev)
>  {
> +	irq_handler_t bcm2835_spi_isr_func = bcm2835_spi_interrupt;
>  	struct spi_controller *ctlr;
> +	unsigned long flags = 0;
> +	struct device_node *dn;
>  	struct bcm2835_spi *bs;
>  	int err;
>  
> +	/* On BCM2711 there can be multiple SPI controllers enabled sharing the
> +	 * same interrupt line, but we also want to minimize the overhead if
> +	 * there is no need to support interrupt sharing. If we find at least
> +	 * another available instane (not counting the one we are probed from),

"instance"

> +	 * then we assume that interrupt sharing is necessary.
> +	 */
> +	for_each_compatible_node(dn, NULL, bcm2835_spi_match[0].compatible) {
> +		err = of_device_is_available(dn) && dn != pdev->dev.of_node;

nit: maybe err is not the ideal variable name here.

> +		of_node_put(dn);
> +		if (err) {
> +			flags = IRQF_SHARED;
> +			bcm2835_spi_isr_func = bcm2835_spi_shared_interrupt;
> +			break;
> +		}
> +	}
> +
>  	ctlr = spi_alloc_master(&pdev->dev, ALIGN(sizeof(*bs),
>  						  dma_get_cache_alignment()));
>  	if (!ctlr)
> @@ -1344,8 +1389,8 @@ static int bcm2835_spi_probe(struct platform_device
> *pdev)
>  	bcm2835_wr(bs, BCM2835_SPI_CS,
>  		   BCM2835_SPI_CS_CLEAR_RX | BCM2835_SPI_CS_CLEAR_TX);
>  
> -	err = devm_request_irq(&pdev->dev, bs->irq, bcm2835_spi_interrupt, 0,
> -			       dev_name(&pdev->dev), ctlr);
> +	err = devm_request_irq(&pdev->dev, bs->irq, bcm2835_spi_isr_func,
> +			       flags, dev_name(&pdev->dev), ctlr);
>  	if (err) {
>  		dev_err(&pdev->dev, "could not request IRQ: %d\n", err);
>  		goto out_dma_release;
> @@ -1400,12 +1445,6 @@ static void bcm2835_spi_shutdown(struct platform_device
> *pdev)
>  		dev_err(&pdev->dev, "failed to shutdown\n");
>  }
>  
> -static const struct of_device_id bcm2835_spi_match[] = {
> -	{ .compatible = "brcm,bcm2835-spi", },
> -	{}
> -};
> -MODULE_DEVICE_TABLE(of, bcm2835_spi_match);
> -
>  static struct platform_driver bcm2835_spi_driver = {
>  	.driver		= {
>  		.name		= DRV_NAME,

Attachment: signature.asc
Description: This is a digitally signed message part


[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux