On Fri, May 29, 2020 at 1:24 PM Dan Murphy <dmurphy@xxxxxx> wrote: > > Rob > > On 5/29/20 1:25 PM, Rob Herring wrote: > > On Wed, May 27, 2020 at 11:49:31AM -0500, Dan Murphy wrote: > >> tx-internal-delays and rx-internal-delays are a common setting for RGMII > >> capable devices. > >> > >> These properties are used when the phy-mode or phy-controller is set to > >> rgmii-id, rgmii-rxid or rgmii-txid. These modes indicate to the > >> controller that the PHY will add the internal delay for the connection. > >> > >> Signed-off-by: Dan Murphy <dmurphy@xxxxxx> > >> --- > >> .../bindings/net/ethernet-controller.yaml | 14 ++++++++++++++ > >> 1 file changed, 14 insertions(+) > >> > >> diff --git a/Documentation/devicetree/bindings/net/ethernet-controller.yaml b/Documentation/devicetree/bindings/net/ethernet-controller.yaml > >> index ac471b60ed6a..70702a4ef5e8 100644 > >> --- a/Documentation/devicetree/bindings/net/ethernet-controller.yaml > >> +++ b/Documentation/devicetree/bindings/net/ethernet-controller.yaml > >> @@ -143,6 +143,20 @@ properties: > >> Specifies the PHY management type. If auto is set and fixed-link > >> is not specified, it uses MDIO for management. > >> > >> + rx-internal-delay-ps: > >> + $ref: /schemas/types.yaml#definitions/uint32 > >> + description: | > >> + RGMII Receive PHY Clock Delay defined in pico seconds. This is used for > >> + PHY's that have configurable RX internal delays. This property is only > >> + used when the phy-mode or phy-connection-type is rgmii-id or rgmii-rxid. > > Isn't this a property of the phy (this is the controller schema)? Looks > > like we have similar properties already and they go in phy nodes. Would > > be good to have a standard property, but let's be clear where it goes. > > > > We need to add '-ps' as a standard unit suffix (in dt-schema) and then a > > type is not needed here. > > This is a PHY specific property. > > I will move them. > > Dumb question but you can just point me to the manual about how and > where to add the '-ps' to the dt-schema Here[1], but looks like I already added it. I'd checked the old kernel version (property-units.txt) which didn't have it. Rob [1] https://github.com/devicetree-org/dt-schema/blob/master/schemas/property-units.yaml#L48