According to https://www.kernel.org/doc/Documentation/gpio/consumer.txt, - all of the gpiod_set_value_xxx() functions operate with the *logical* value. So in imx290_power_on() the reset signal should be cleared/de-asserted with gpiod_set_value_cansleep(imx290->rst_gpio, 0), and in imx290_power_off() the value of 1 must be used to apply/assert the reset to the sensor. In the device tree the reset pin is described as GPIO_ACTIVE_LOW, and gpiod_set_value_xxx() functions take this into account, - when devm_gpiod_get_optional() is called with GPIOD_ASIS, the GPIO is not initialized, and the direction must be set later; using a GPIO without setting its direction first is illegal and will result in undefined behavior. Fix this by using GPIOD_OUT_HIGH instead of GPIOD_ASIS (this asserts the reset signal to the sensor initially). Signed-off-by: Andrey Konovalov <andrey.konovalov@xxxxxxxxxx> Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> --- drivers/media/i2c/imx290.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) diff --git a/drivers/media/i2c/imx290.c b/drivers/media/i2c/imx290.c index d0322f9a8856..7b1de1f0c8b7 100644 --- a/drivers/media/i2c/imx290.c +++ b/drivers/media/i2c/imx290.c @@ -628,7 +628,7 @@ static int imx290_power_on(struct device *dev) } usleep_range(1, 2); - gpiod_set_value_cansleep(imx290->rst_gpio, 1); + gpiod_set_value_cansleep(imx290->rst_gpio, 0); usleep_range(30000, 31000); return 0; @@ -641,7 +641,7 @@ static int imx290_power_off(struct device *dev) struct imx290 *imx290 = to_imx290(sd); clk_disable_unprepare(imx290->xclk); - gpiod_set_value_cansleep(imx290->rst_gpio, 0); + gpiod_set_value_cansleep(imx290->rst_gpio, 1); regulator_bulk_disable(IMX290_NUM_SUPPLIES, imx290->supplies); return 0; @@ -757,7 +757,8 @@ static int imx290_probe(struct i2c_client *client) goto free_err; } - imx290->rst_gpio = devm_gpiod_get_optional(dev, "reset", GPIOD_ASIS); + imx290->rst_gpio = devm_gpiod_get_optional(dev, "reset", + GPIOD_OUT_HIGH); if (IS_ERR(imx290->rst_gpio)) { dev_err(dev, "Cannot get reset gpio\n"); ret = PTR_ERR(imx290->rst_gpio); -- 2.17.1
