Correct ldo1 voltage range from wrong high group(3.0v~3.3v) to low group
(1.6v~1.9v) because the ldo1 should be 1.8v. Actually, two voltage groups
have been supported at bd718x7-regulator driver, hence, just corrrect the
voltage range to 1.6v~3.3v. For ldo2@0.8v, correct voltage range too.
Otherwise, ldo1 would be kept @3.0v and ldo2@0.9v which violate i.mx8mm
datasheet as the below warning log in kernel:
[ 0.995524] LDO1: Bringing 1800000uV into 3000000-3000000uV
[ 0.999196] LDO2: Bringing 800000uV into 900000-900000uV
Signed-off-by: Robin Gong <yibin.gong@xxxxxxx>
---
arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts | 4 ++--
arch/arm64/boot/dts/freescale/imx8mn-evk.dts | 9 +++++++++
2 files changed, 11 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts b/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
index d07e0e6..a1e5483 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
@@ -113,7 +113,7 @@
ldo1_reg: LDO1 {
regulator-name = "LDO1";
- regulator-min-microvolt = <3000000>;
+ regulator-min-microvolt = <1600000>;
regulator-max-microvolt = <3300000>;
regulator-boot-on;
regulator-always-on;
@@ -121,7 +121,7 @@
ldo2_reg: LDO2 {
regulator-name = "LDO2";
- regulator-min-microvolt = <900000>;
+ regulator-min-microvolt = <800000>;
regulator-max-microvolt = <900000>;
regulator-boot-on;
regulator-always-on;
diff --git a/arch/arm64/boot/dts/freescale/imx8mn-evk.dts b/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
index 61f3519..117ff4b 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
@@ -13,6 +13,15 @@
compatible = "fsl,imx8mn-evk", "fsl,imx8mn";
};
+&ecspi1 {
+ status = "okay";
+spidev0: spi@0 {
+ compatible = "ge,achc";
+ reg = <0>;
+ spi-max-frequency = <1000000>;
+ };
+};
+
&A53_0 {
/delete-property/operating-points-v2;
};
--
2.7.4
