changes v7: - VT7: reorder node alphabetically - VT7: rename "reg_12v_bl: regulator-bl-12v" to "reg_bl_12v0: regulator-bl-12v0" - VT7: remove panel and TS nodes. This drivers are currently not mainline. - prti6q.dtsi: move reg_1v8 to prti6q.dts - prti6q.dtsi: remove pinctrl from the can1 node. It is done on almost every board file. changes v6: - move fsl.yaml changes to separate patch - remove partitions, they are provided by the bootloader - update flash compatible - rename can3 to can - fix fsl,mode - fix interrupt in the wlan node on PRTI6Q changes v5: - PRTI6Q: remove status from the pwm-backlight node - drop the vendor-prefixes patch, it is already taken by Rob - add Reviewed-by: Rob Herring <robh@xxxxxxxxxx> changes v4: - VT7: fix typo changes v3: - move compatible to the start of node - move status to the end - use generic names in compatible - refactor dts/dtsi - use alphabet order for pinctrl and phandels - remove unused or currently not supported nodes changes v2: - squash PRTI6Q patches Oleksij Rempel (5): ARM: dts: add Protonic PRTI6Q board ARM: dts: add Protonic WD2 board ARM: dts: add Protonic VT7 board ARM: dts: add Protonic RVT board dt-bindings: arm: fsl: add different Protonic boards .../devicetree/bindings/arm/fsl.yaml | 4 + arch/arm/boot/dts/Makefile | 4 + arch/arm/boot/dts/imx6dl-prtrvt.dts | 182 ++++++ arch/arm/boot/dts/imx6dl-prtvt7.dts | 472 ++++++++++++++++ arch/arm/boot/dts/imx6q-prti6q.dts | 529 ++++++++++++++++++ arch/arm/boot/dts/imx6q-prtwd2.dts | 188 +++++++ arch/arm/boot/dts/imx6qdl-prti6q.dtsi | 174 ++++++ 7 files changed, 1553 insertions(+) create mode 100644 arch/arm/boot/dts/imx6dl-prtrvt.dts create mode 100644 arch/arm/boot/dts/imx6dl-prtvt7.dts create mode 100644 arch/arm/boot/dts/imx6q-prti6q.dts create mode 100644 arch/arm/boot/dts/imx6q-prtwd2.dts create mode 100644 arch/arm/boot/dts/imx6qdl-prti6q.dtsi -- 2.26.2
