If the op-mode for the device is not set in the device tree then set the strapped op-mode and store it for later configuration. Signed-off-by: Dan Murphy <dmurphy@xxxxxx> --- drivers/net/phy/dp83869.c | 21 ++++++++++++++++++++- 1 file changed, 20 insertions(+), 1 deletion(-) diff --git a/drivers/net/phy/dp83869.c b/drivers/net/phy/dp83869.c index 073a0f7754a5..64fa2d911074 100644 --- a/drivers/net/phy/dp83869.c +++ b/drivers/net/phy/dp83869.c @@ -65,6 +65,7 @@ #define DP83869_RGMII_RX_CLK_DELAY_EN BIT(0) /* STRAP_STS1 bits */ +#define DP83869_STRAP_OP_MODE_MASK GENMASK(2, 0) #define DP83869_STRAP_STS1_RESERVED BIT(11) #define DP83869_STRAP_MIRROR_ENABLED BIT(12) @@ -161,6 +162,20 @@ static int dp83869_config_port_mirroring(struct phy_device *phydev) DP83869_CFG3_PORT_MIRROR_EN); } +static int dp83869_set_strapped_mode(struct phy_device *phydev) +{ + struct dp83869_private *dp83869 = phydev->priv; + u16 val; + + val = phy_read_mmd(phydev, DP83869_DEVADDR, DP83869_STRAP_STS1); + if (val < 0) + return val; + + dp83869->mode = val & DP83869_STRAP_OP_MODE_MASK; + + return 0; +} + #ifdef CONFIG_OF_MDIO static int dp83869_of_init(struct phy_device *phydev) { @@ -185,6 +200,10 @@ static int dp83869_of_init(struct phy_device *phydev) if (dp83869->mode < DP83869_RGMII_COPPER_ETHERNET || dp83869->mode > DP83869_SGMII_COPPER_ETHERNET) return -EINVAL; + } else { + ret = dp83869_set_strapped_mode(phydev); + if (ret) + return ret; } if (of_property_read_bool(of_node, "ti,max-output-impedance")) @@ -218,7 +237,7 @@ static int dp83869_of_init(struct phy_device *phydev) #else static int dp83869_of_init(struct phy_device *phydev) { - return 0; + return dp83869_set_strapped_mode(phydev); } #endif /* CONFIG_OF_MDIO */ -- 2.26.2