On Tue, May 12, 2020 at 01:32:30AM +0800, Robin Gong wrote: > Change to XCH mode even in dma mode, please refer to the below > errata: > https://www.nxp.com/docs/en/errata/IMX6DQCE.pdf > > Signed-off-by: Robin Gong <yibin.gong@xxxxxxx> > Acked-by: Mark Brown <broonie@xxxxxxxxxx> > --- > drivers/spi/spi-imx.c | 16 ++++++++-------- > 1 file changed, 8 insertions(+), 8 deletions(-) > > diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c > index f4f28a4..70df8e6 100644 > --- a/drivers/spi/spi-imx.c > +++ b/drivers/spi/spi-imx.c > @@ -585,8 +585,8 @@ static int mx51_ecspi_prepare_transfer(struct spi_imx_data *spi_imx, > ctrl |= mx51_ecspi_clkdiv(spi_imx, t->speed_hz, &clk); > spi_imx->spi_bus_clk = clk; > > - if (spi_imx->usedma) > - ctrl |= MX51_ECSPI_CTRL_SMC; > + /* ERR009165: work in XHC mode as PIO */ > + ctrl &= ~MX51_ECSPI_CTRL_SMC; > > writel(ctrl, spi_imx->base + MX51_ECSPI_CTRL); > > @@ -617,7 +617,7 @@ static void mx51_setup_wml(struct spi_imx_data *spi_imx) > * and enable DMA request. > */ > writel(MX51_ECSPI_DMA_RX_WML(spi_imx->wml - 1) | > - MX51_ECSPI_DMA_TX_WML(spi_imx->wml) | > + MX51_ECSPI_DMA_TX_WML(0) | > MX51_ECSPI_DMA_RXT_WML(spi_imx->wml) | > MX51_ECSPI_DMA_TEDEN | MX51_ECSPI_DMA_RXDEN | > MX51_ECSPI_DMA_RXTDEN, spi_imx->base + MX51_ECSPI_DMA); > @@ -1171,7 +1171,11 @@ static int spi_imx_dma_configure(struct spi_master *master) > tx.direction = DMA_MEM_TO_DEV; > tx.dst_addr = spi_imx->base_phys + MXC_CSPITXDATA; > tx.dst_addr_width = buswidth; > - tx.dst_maxburst = spi_imx->wml; > + /* > + * For ERR009165 with tx_wml = 0 could enlarge burst size to fifo size > + * to speed up fifo filling as possible. > + */ > + tx.dst_maxburst = spi_imx->devtype_data->fifo_size; In the next patch this is changed again to: + if (spi_imx->devtype_data->tx_glitch_fixed) + tx.dst_maxburst = spi_imx->wml; + else + tx.dst_maxburst = spi_imx->devtype_data->fifo_size; So with tx_glitch_fixed we end up with tx.dst_maxburst being the same as two patches before which is rather confusing. Better introduce tx_glitch_fixed in this patch, or maybe even merge this patch and the next one. Sascha -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
