Re: [PATCH v2 04/18] video: add command mode and command mode display timing

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hi Therry

On 05/21/2014 08:02 PM, Thierry Reding wrote:
On Wed, May 21, 2014 at 01:42:56PM +0900, YoungJun Cho wrote:
This patch is based on videomode and display_timing relevant codes.
To support command mode panel, it does not need to guide its timing
information to the display controller like video mode panel,
but it requires signal timings to transfer video data.
So this patch adds cmdmode struct, cmdmode_display_timing struct and
the according helper functions to convert cmdmode_display_timing
to a generic cmdmode.

Can you point me to relevant documentation? I wasn't able to find it by
a quick scan through the DSI specification.


I'm sorry to say that there is no specific one document.

I referred to several ones, CPU interface, I80 interface and
DBI document(last time you said it).
I think this is good to check it.
[ http://cache.freescale.com/files/dsp/doc/app_note/AN4180.pdf ]

And I asked panel vendor custom service centre also.

Thank you.
Best regards YJ

Thierry


--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux