Some of the properties pertaining to the broken turn around or resets
were only documented in ethernet-phy.yaml while they are applicable
across all MDIO devices and not Ethernet PHYs specifically which are a
superset.
Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
.../devicetree/bindings/net/mdio.yaml | 28 +++++++++++++++++++
1 file changed, 28 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/mdio.yaml b/Documentation/devicetree/bindings/net/mdio.yaml
index 50c3397a82bc..9efb7d623f0e 100644
--- a/Documentation/devicetree/bindings/net/mdio.yaml
+++ b/Documentation/devicetree/bindings/net/mdio.yaml
@@ -50,6 +50,34 @@ patternProperties:
description:
The ID number for the PHY.
+ broken-turn-around:
+ $ref: /schemas/types.yaml#definitions/flag
+ description:
+ If set, indicates the MDIO device does not correctly release
+ the turn around line low at end of the control phase of the
+ MDIO transaction.
+
+ resets:
+ maxItems: 1
+
+ reset-names:
+ const: phy
+
+ reset-gpios:
+ maxItems: 1
+ description:
+ The GPIO phandle and specifier for the MDIO reset signal.
+
+ reset-assert-us:
+ description:
+ Delay after the reset was asserted in microseconds. If this
+ property is missing the delay will be skipped.
+
+ reset-deassert-us:
+ description:
+ Delay after the reset was deasserted in microseconds. If
+ this property is missing the delay will be skipped.
+
required:
- reg
--
2.19.1
