A number of descriptions assume a PHY device, but since this binding
describes a MDIO bus which can have different kinds of MDIO devices
attached to it, rephrase some descriptions to be more general in that
regard.
Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
Documentation/devicetree/bindings/net/mdio.yaml | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/mdio.yaml b/Documentation/devicetree/bindings/net/mdio.yaml
index d268ed80bb77..7ea0b5510bc3 100644
--- a/Documentation/devicetree/bindings/net/mdio.yaml
+++ b/Documentation/devicetree/bindings/net/mdio.yaml
@@ -31,13 +31,13 @@ properties:
maxItems: 1
description:
The phandle and specifier for the GPIO that controls the RESET
- lines of all PHYs on that MDIO bus.
+ lines of all devices on that MDIO bus.
reset-delay-us:
description:
- RESET pulse width in microseconds. It applies to all PHY devices
- and must therefore be appropriately determined based on all PHY
- requirements (maximum value of all per-PHY RESET pulse widths).
+ RESET pulse width in microseconds. It applies to all MDIO devices
+ and must therefore be appropriately determined based on all devices
+ requirements (maximum value of all per-device RESET pulse widths).
patternProperties:
"^ethernet-phy@[0-9a-f]+$":
@@ -48,7 +48,7 @@ patternProperties:
minimum: 0
maximum: 31
description:
- The ID number for the PHY.
+ The ID number for the device.
broken-turn-around:
$ref: /schemas/types.yaml#definitions/flag
--
2.19.1
