On Tue, Apr 14, 2020 at 06:08:38PM +0200, Willy Tarreau wrote: > Hi, > > On Tue, Apr 14, 2020 at 07:03:54PM +0300, Sergey Matyukevich wrote: > > I have not changed configuration since 5.3, so all the marvell phy > > drivers are in place. Is there anything in configuration that could > > be missed after moving from 5.3 to 5.6 kernel ? > > FWIW mine works perfectly fine with 5.4 at 1G/2.5G/10G. From what I can > quickly check here are the relevant parts in my config for ethernet (not > sure all are needed though): > > CONFIG_NET_VENDOR_MARVELL=y > CONFIG_MVMDIO=y > CONFIG_MVPP2=y > CONFIG_MDIO_DEVICE=y > CONFIG_MDIO_BUS=y > CONFIG_MDIO_BITBANG=y Macchiatobin doesn't bitbang the MDIO bus. > CONFIG_MDIO_BUS_MUX=y > CONFIG_MDIO_BUS_MUX_MMIOREG=y > CONFIG_MDIO_BUS_MUX_MULTIPLEXER=y There's no MDIO bus muxing on Macchiatobin. > CONFIG_MDIO_I2C=y > CONFIG_PHYLINK=y > CONFIG_PHYLIB=y > CONFIG_SWPHY=y > CONFIG_SFP=y > CONFIG_FIXED_PHY=y CONFIG_FIXED_PHY should no longer be required. > CONFIG_MARVELL_PHY=y > CONFIG_MARVELL_10G_PHY=y > > Not tested 5.6 yet. > > Hoping this helps, > Willy > -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line in suburbia: sync at 10.2Mbps down 587kbps up
