On Thu, Mar 26, 2020 at 04:32:51PM -0500, Adam Ford wrote:
> The Versaclock can be purchased in a non-programmed configuration.
> If that is the case, the driver needs to configure the chip to
> output the correct signal type, voltage and slew.
>
> This RFC is proposing an additional binding to allow non-programmed
> chips to be configured beyond their default configuration.
>
> Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
>
> diff --git a/Documentation/devicetree/bindings/clock/idt,versaclock5.txt b/Documentation/devicetree/bindings/clock/idt,versaclock5.txt
> index 05a245c9df08..4bc46ed9ba4a 100644
> --- a/Documentation/devicetree/bindings/clock/idt,versaclock5.txt
> +++ b/Documentation/devicetree/bindings/clock/idt,versaclock5.txt
> @@ -30,6 +30,25 @@ Required properties:
> - 5p49v5933 and
> - 5p49v5935: (optional) property not present or "clkin".
>
> +For all output ports, an option child node can be used to specify:
> +
> +- mode: can be one of
> + - LVPECL: Low-voltage positive/psuedo emitter-coupled logic
> + - CMOS
> + - HCSL
> + - LVDS: Low voltage differential signal
> +
> +- voltage-level: can be one of the following microvolts
> + - 1800000
> + - 2500000
> + - 3300000
> +- slew: Percent of normal, can be one of
> + - P80
> + - P85
> + - P90
> + - P100
> +
> +
> ==Mapping between clock specifier and physical pins==
>
> When referencing the provided clock in the DT using phandle and
> @@ -62,6 +81,8 @@ clock specifier, the following mapping applies:
>
> ==Example==
>
> +#include <dt-bindings/versaclock.h>
> +
> /* 25MHz reference crystal */
> ref25: ref25m {
> compatible = "fixed-clock";
> @@ -80,6 +101,13 @@ i2c-master-node {
> /* Connect XIN input to 25MHz reference */
> clocks = <&ref25m>;
> clock-names = "xin";
> +
> + ports@1 {
'ports' is already taken as a node name.
> + reg = <1>;
What do the reg value signify?
> + mode = <CMOS>;
> + pwr_sel = <1800000>;
Not documented. Don't use '-' in property names.
> + slew = <P80>;
> + };
> };
> };
>
> --
> 2.25.1
>
