[PATCH 2/2] ARM: dts: apalis-imx6qdl: use rgmii-id instead of rgmii

[Philippe Schenker <philippe.schenker@xxxxxxxxxxx>]

Until now a PHY-fixup in mach-imx set our rgmii timing correctly. For
the PHY KSZ9131 there is no PHY-fixup in mach-imx. To support this PHY
too, use rgmii-id.
For the now used KSZ9031 nothing will change, as rgmii-id is only
implemented and supported by the KSZ9131.

Signed-off-by: Philippe Schenker <philippe.schenker@xxxxxxxxxxx>

---

 arch/arm/boot/dts/imx6qdl-apalis.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
index 1b5bc6b5e806..347a5edc6927 100644
--- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
@@ -180,7 +180,7 @@ &ecspi2 {
 &fec {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_enet>;
-	phy-mode = "rgmii";
+	phy-mode = "rgmii-id";
 	phy-handle = <&ethphy>;
 	phy-reset-duration = <10>;
 	phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
-- 
2.26.0