* Roger Quadros <rogerq@xxxxxx> [200311 07:21]: > > > On 10/03/2020 17:48, Tony Lindgren wrote: > > * Tero Kristo <t-kristo@xxxxxx> [200310 14:46]: > > > On 10/03/2020 13:53, Roger Quadros wrote: > > > > The L3 interconnect can access only 32-bits of address. > > > > Add the dma-ranges property to reflect this limit. > > > > > > > > This will ensure that no device under L3 is > > > > given > 32-bit address for DMA. > > > > > > > > Issue was observed only with SATA on DRA7-EVM with 4GB RAM > > > > and CONFIG_ARM_LPAE enabled. This is because the controller > > > > can perform 64-bit DMA and was setting the dma_mask to 64-bit. > > > > > > > > Setting the correct bus_dma_limit fixes the issue. > > > > > > This seems kind of messy to modify almost every DT node because of this.... > > > Are you sure this is the only way to get it done? No way to modify the sata > > > node only which is impacted somehow? > > > > > > Also, what if you just pass 0xffffffff to the dma-ranges property? That > > > would avoid modifying every node I guess. > > > > Also, I think these interconnects are not limited to 32-bit access. > > But from Table 2-1. L3_MAIN Memory Map > > Start address 0x0000_0000 > End address 0xFFFF_FFFF > > So it is 32-bit limit, right? Hmm so what war Robin saying earlier that DMA access seems to be limited to lower 2GB only though? Regards, Tony
