With the introduction of SDHCI_QUIRK2_SET_BUS_VOLTAGE there is no need
to use a custom set_power() implementation as the quirk takes care of
configuring the bus voltage register even when powering trough a
regulator.
Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@xxxxxxx>
---
drivers/mmc/host/sdhci-milbeaut.c | 15 ++-------------
1 file changed, 2 insertions(+), 13 deletions(-)
diff --git a/drivers/mmc/host/sdhci-milbeaut.c b/drivers/mmc/host/sdhci-milbeaut.c
index 92f30a1db435..6a935554c54d 100644
--- a/drivers/mmc/host/sdhci-milbeaut.c
+++ b/drivers/mmc/host/sdhci-milbeaut.c
@@ -121,17 +121,6 @@ static void sdhci_milbeaut_reset(struct sdhci_host *host, u8 mask)
}
}
-static void sdhci_milbeaut_set_power(struct sdhci_host *host,
- unsigned char mode, unsigned short vdd)
-{
- if (!IS_ERR(host->mmc->supply.vmmc)) {
- struct mmc_host *mmc = host->mmc;
-
- mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, vdd);
- }
- sdhci_set_power_noreg(host, mode, vdd);
-}
-
static const struct sdhci_ops sdhci_milbeaut_ops = {
.voltage_switch = sdhci_milbeaut_soft_voltage_switch,
.get_min_clock = sdhci_milbeaut_get_min_clock,
@@ -139,7 +128,6 @@ static const struct sdhci_ops sdhci_milbeaut_ops = {
.set_clock = sdhci_set_clock,
.set_bus_width = sdhci_set_bus_width,
.set_uhs_signaling = sdhci_set_uhs_signaling,
- .set_power = sdhci_milbeaut_set_power,
};
static void sdhci_milbeaut_bridge_reset(struct sdhci_host *host,
@@ -262,7 +250,8 @@ static int sdhci_milbeaut_probe(struct platform_device *pdev)
SDHCI_QUIRK_DELAY_AFTER_POWER;
host->quirks2 = SDHCI_QUIRK2_SUPPORT_SINGLE |
SDHCI_QUIRK2_TUNING_WORK_AROUND |
- SDHCI_QUIRK2_PRESET_VALUE_BROKEN;
+ SDHCI_QUIRK2_PRESET_VALUE_BROKEN |
+ SDHCI_QUIRK2_SET_BUS_VOLTAGE;
priv->enable_cmd_dat_delay = device_property_read_bool(dev,
"fujitsu,cmd-dat-delay-select");
--
2.25.1
