On STM32MP1 DK1, DK2, ED1 and EV1 boards, there is only a micro SD socket. This is also the case on Avenger board. They don't support the Write Protect pin. The disable-wp is then added in the SD-cards sdmmc1 nodes. This avoids executing some code and a warning during driver probe. Signed-off-by: Yann Gautier <yann.gautier@xxxxxx> --- arch/arm/boot/dts/stm32mp157a-avenger96.dts | 1 + arch/arm/boot/dts/stm32mp157c-ed1.dts | 1 + arch/arm/boot/dts/stm32mp15xx-dkx.dtsi | 1 + 3 files changed, 3 insertions(+) diff --git a/arch/arm/boot/dts/stm32mp157a-avenger96.dts b/arch/arm/boot/dts/stm32mp157a-avenger96.dts index 2bdfab192a39..8e060219751b 100644 --- a/arch/arm/boot/dts/stm32mp157a-avenger96.dts +++ b/arch/arm/boot/dts/stm32mp157a-avenger96.dts @@ -301,6 +301,7 @@ pinctrl-1 = <&sdmmc1_b4_od_pins_a>; pinctrl-2 = <&sdmmc1_b4_sleep_pins_a>; cd-gpios = <&gpioi 8 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; + disable-wp; st,sig-dir; st,neg-edge; st,use-ckin; diff --git a/arch/arm/boot/dts/stm32mp157c-ed1.dts b/arch/arm/boot/dts/stm32mp157c-ed1.dts index 5daaec3aec9b..6f8d23a7d4a6 100644 --- a/arch/arm/boot/dts/stm32mp157c-ed1.dts +++ b/arch/arm/boot/dts/stm32mp157c-ed1.dts @@ -314,6 +314,7 @@ pinctrl-1 = <&sdmmc1_b4_od_pins_a &sdmmc1_dir_pins_a>; pinctrl-2 = <&sdmmc1_b4_sleep_pins_a &sdmmc1_dir_sleep_pins_a>; cd-gpios = <&gpiog 1 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; + disable-wp; st,sig-dir; st,neg-edge; st,use-ckin; diff --git a/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi b/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi index 02d52eb3c34f..6897119cadc9 100644 --- a/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi +++ b/arch/arm/boot/dts/stm32mp15xx-dkx.dtsi @@ -480,6 +480,7 @@ pinctrl-1 = <&sdmmc1_b4_od_pins_a>; pinctrl-2 = <&sdmmc1_b4_sleep_pins_a>; cd-gpios = <&gpiob 7 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; + disable-wp; st,neg-edge; bus-width = <4>; vmmc-supply = <&v3v3>; -- 2.17.1
