Add DT node for MCU System Control module DT node and DT node for the TI
J721E SoC phy-gmii-sel PHY required for Ethernet ports mode selection.
Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx>
---
arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
index 16c874bfd49a..6f961d5f077a 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
@@ -34,6 +34,20 @@
};
};
+ mcu_conf: syscon@40f00000 {
+ compatible = "syscon", "simple-mfd";
+ reg = <0x0 0x40f00000 0x0 0x20000>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0x0 0x0 0x40f00000 0x20000>;
+
+ phy_gmii_sel: phy@4040 {
+ compatible = "ti,am654-phy-gmii-sel";
+ reg = <0x4040 0x4>;
+ #phy-cells = <1>;
+ };
+ };
+
wkup_pmx0: pinmux@4301c000 {
compatible = "pinctrl-single";
/* Proxy 0 addressing */
--
2.17.1
