a) add DT node for SW1 as Enter button
The SW1 button can be used as a simple one-button keyboard
and is connected to PD17.
Note: SW1 has a second meaning to change the boot sequence
when pressed while powering on.
b) give eth0_power a defined voltage.
This is a 3.3V power switch (DVNET3.3V).
Signed-off-by: H. Nikolaus Schaller <hns@xxxxxxxxxxxxx>
Reviewed-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
---
arch/mips/boot/dts/ingenic/ci20.dts | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/arch/mips/boot/dts/ingenic/ci20.dts b/arch/mips/boot/dts/ingenic/ci20.dts
index 0251ca154ccb..ce6bf7e7dbba 100644
--- a/arch/mips/boot/dts/ingenic/ci20.dts
+++ b/arch/mips/boot/dts/ingenic/ci20.dts
@@ -4,6 +4,7 @@
#include "jz4780.dtsi"
#include <dt-bindings/clock/ingenic,tcu.h>
#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/regulator/active-semi,8865-regulator.h>
@@ -27,6 +28,17 @@
0x30000000 0x30000000>;
};
+ gpio-keys {
+ compatible = "gpio-keys";
+
+ sw1 {
+ label = "ci20:sw1";
+ linux,code = <KEY_F13>;
+ gpios = <&gpd 17 GPIO_ACTIVE_HIGH>;
+ wakeup-source;
+ };
+ };
+
leds {
compatible = "gpio-leds";
@@ -58,6 +70,8 @@
eth0_power: fixedregulator@0 {
compatible = "regulator-fixed";
regulator-name = "eth0_power";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
gpio = <&gpb 25 GPIO_ACTIVE_LOW>;
enable-active-high;
};
--
2.23.0
