Hi, This series is for the Exynos DRM driver to support MIPI DSI command mode display and based on exynos-drm-next branch. The previous patches, RFC: http://www.spinics.net/lists/dri-devel/msg58898.html Patches 1 and 2 fix trivial bugs. Patches 3 and 4 introduce command mode and command mode display timing. These are based on video mode and (video mode) display timing. The MIPI DSI command mode interface panel does not require (video mode) display timing, but it requires signal timings to distinguish command data and video data so command mode and command mode display timing are used for it. Patch 5 converts command mode to drm display mode. Patches 6, 7, 8, 9 and 10 implement FIMD(display controller) I80 interface. The MIPI DSI command mode interface panel generates Tearing Effect synchronization signal between MCU and FB to display video image, and FIMD should trigger to transfer video image at this signal. So the panel should receive the TE IRQ then calls TE handler chains to notify it to the FIMD. Patches 11 and 12 implement to use Exynos5420 SoC DSI driver which is different from previous Exynos4 SoCs for some registers control. Patches 13 and 14 introduce MIPI DSI command interface Samsung S6E3FA0 AMOLED 5.7" LCD panel driver. Patch 15 is device tree source file for Exynos4 SoCs to support MIPI DSI command mode. The others are device tree source files for Exynos5420 to support MIPI DSI (command mode) driver. I welcome any comments. Thank you. Best regards YJ YoungJun Cho (18): drm/exynos: dsi: move the EoT packets configuration point drm/exynos: use wait_event_timeout() for safety usage ARM: dts: video: add command mode display timing DT bindings video: add command mode and command mode display timing drm_modes: add command mode helpers ARM: dts: sysreg: add exynos5 compatible to DT bindings ARM: dts: samsung-fimd: add I80 specific properties drm/exynos: add TE handler to support MIPI DSI command mode interface drm/exynos: dsi: add TE handler to support command mode interface drm/exynos: fimd: support I80 interface ARM: dts: exynos_dsim: add exynos5420 compatible to DT bindings drm/exynos: dsi: add driver data to support Exynos5420 ARM: dts: s6e3fa0: add DT bindings drm/panel: add S6E3FA0 driver ARM: dts: exynos4: add system register node ARM: dts: exynos5: add system register support ARM: dts: exynos5420: add mipi-phy node ARM: dts: exynos5420: add dsi node .../devicetree/bindings/arm/samsung/sysreg.txt | 1 + .../devicetree/bindings/panel/samsung,s6e3fa0.txt | 45 ++ .../bindings/video/cmdmode-display-timing.txt | 64 +++ .../devicetree/bindings/video/exynos_dsim.txt | 4 +- .../devicetree/bindings/video/samsung-fimd.txt | 2 + arch/arm/boot/dts/exynos4.dtsi | 1 + arch/arm/boot/dts/exynos5.dtsi | 6 + arch/arm/boot/dts/exynos5420.dtsi | 20 + drivers/gpu/drm/drm_modes.c | 59 ++ drivers/gpu/drm/exynos/Kconfig | 1 + drivers/gpu/drm/exynos/exynos_drm_crtc.c | 16 +- drivers/gpu/drm/exynos/exynos_drm_crtc.h | 7 + drivers/gpu/drm/exynos/exynos_drm_drv.h | 3 + drivers/gpu/drm/exynos/exynos_drm_dsi.c | 175 +++++- drivers/gpu/drm/exynos/exynos_drm_fimd.c | 277 ++++++++-- drivers/gpu/drm/panel/Kconfig | 7 + drivers/gpu/drm/panel/Makefile | 1 + drivers/gpu/drm/panel/panel-s6e3fa0.c | 570 ++++++++++++++++++++ drivers/video/Kconfig | 3 + drivers/video/Makefile | 2 + drivers/video/cmdmode.c | 42 ++ drivers/video/cmdmode_display_timing.c | 26 + drivers/video/of_cmdmode.c | 55 ++ drivers/video/of_cmdmode_display_timing.c | 212 ++++++++ include/drm/drm_mipi_dsi.h | 8 + include/drm/drm_modes.h | 12 + include/video/cmdmode.h | 67 +++ include/video/cmdmode_display_timing.h | 59 ++ include/video/of_cmdmode.h | 19 + include/video/of_cmdmode_display_timing.h | 26 + include/video/samsung_fimd.h | 3 +- 31 files changed, 1722 insertions(+), 71 deletions(-) create mode 100644 Documentation/devicetree/bindings/panel/samsung,s6e3fa0.txt create mode 100644 Documentation/devicetree/bindings/video/cmdmode-display-timing.txt create mode 100644 drivers/gpu/drm/panel/panel-s6e3fa0.c create mode 100644 drivers/video/cmdmode.c create mode 100644 drivers/video/cmdmode_display_timing.c create mode 100644 drivers/video/of_cmdmode.c create mode 100644 drivers/video/of_cmdmode_display_timing.c create mode 100644 include/video/cmdmode.h create mode 100644 include/video/cmdmode_display_timing.h create mode 100644 include/video/of_cmdmode.h create mode 100644 include/video/of_cmdmode_display_timing.h -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
