RE: [PATCH 0/9] remoteproc: imx_rproc: support i.MX8/8M/7ULP

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Oleksij,

> Subject: Re: [PATCH 0/9] remoteproc: imx_rproc: support i.MX8/8M/7ULP
> 
> Hi Peng,
> 
> i can't apply your patches on kernel master HEAD. Do I need some extras?

The patchset is based on Shawn's for-next branch. With Loic' V4 patch
applied as showed in cover-letter.

> 
> Please add me to CC for this driver next time.

I used get_maintainer.pl to get the to/cc list. Will add you in v2, but may
delay for a while, sine early boot stuff not settle down until now.

Thanks,
Peng.

> 
> On Wed, Feb 19, 2020 at 03:27:36PM +0800, peng.fan@xxxxxxx wrote:
> > From: Peng Fan <peng.fan@xxxxxxx>
> >
> > This patchset aim to replace NXP vendor imx_rpmsg.c driver.
> >
> > This patchset is tested with Loic PALLARDY's patch
> > "remoteproc: add support for co-processor loaded and booted before
> kernel"
> > https://patchwork.kernel.org/patch/11265869/,
> > and inspried from st's remoteproc early boot support.
> > Since Loic's patch is still under review, just expect your comments :)
> >
> > Patch [1,2]/9: dt-bindings convert to json and new SoC support Patch
> > 3/9: skip firmware load when recovery. To i.MX8, firmware is not
> >            handled by Linux.
> >
> > Patch [4-9]/9: i.MX specific part to support rpmsg/virtio with mbox.
> >       because NXP release image not have resoure table, so add resource
> >       table in dts
> >
> > My test dts diff for i.MX8QXP MEK, but I have tested this patchset for
> > i.MX8QXP MEK, i.MX8MM EVK, i.MX7ULP EVK:
> >
> > +
> > +	imx8x-cm4 {
> > +		compatible = "fsl,imx8qxp-cm4";
> > +		rsrc-table = <
> > +			0x1 0x2 0x0 0x0 0x18 0x5c
> > +			3
> > +			/*fw_rsc_vdev*/
> > +			7 0 1 0 0 0x200
> > +			/*fw_rsc_vdev_vring*/
> > +			0x90000000 4096 256 1 0
> > +			0x90008000 4096 256 2 0
> > +			3
> > +			/*fw_rsc_vdev*/
> > +			7 1 1 0 0 0x200
> > +			/*fw_rsc_vdev_vring*/
> > +			0x90010000 4096 256 1 0
> > +			0x90018000 4096 256 2 0
> > +		>;
> > +		early-booted;
> > +		mbox-names = "tx", "rx", "rxdb";
> > +		mboxes = <&lsio_mu5 0 1
> > +			  &lsio_mu5 1 1
> > +			  &lsio_mu5 3 1>;
> > +		mub-partition = <3>;
> > +		memory-region = <&vdev0vring0>, <&vdev0vring1>,
> <&vdev0buffer>,
> > +				<&vdev1vring0>, <&vdev1vring1>, <&vdev0buffer>;
> > +	};
> > +
> > +	reserved-memory {
> > +		#address-cells = <2>;
> > +		#size-cells = <2>;
> > +		ranges;
> > +
> > +		vdev0vring0: vdev0vring0@90000000 {
> > +                       compatible = "shared-dma-pool";
> > +			reg = <0 0x90000000 0 0x8000>;
> > +			no-map;
> > +		};
> > +
> > +		vdev0vring1: vdev0vring1@90008000 {
> > +                       compatible = "shared-dma-pool";
> > +			reg = <0 0x90008000 0 0x8000>;
> > +			no-map;
> > +		};
> > +
> > +		vdev1vring0: vdev1vring0@90010000 {
> > +                       compatible = "shared-dma-pool";
> > +			reg = <0 0x90010000 0 0x8000>;
> > +			no-map;
> > +		};
> > +
> > +		vdev1vring1: vdev1vring1@90018000 {
> > +                       compatible = "shared-dma-pool";
> > +			reg = <0 0x90018000 0 0x8000>;
> > +			no-map;
> > +		};
> > +
> > +		vdev0buffer: vdev0buffer {
> > +                       compatible = "shared-dma-pool";
> > +			reg = <0 0x90400000 0 0x100000>;
> > +			no-map;
> > +		};
> > +	};
> > +
> >
> > Peng Fan (9):
> >   dt-bindings: remoteproc: Convert imx-rproc to json-schema
> >   dt-bindings: remoteproc: imx-rproc: support i.MX[8,8M,7ULP]
> >   remoteproc: add support to skip firmware load when recovery
> >   remoteproc: imx_rproc: surport early booted remote processor
> >   remoteproc: imx_rproc: parse early-booted property
> >   remoteproc: imx_proc: enable virtio/mailbox
> >   remoteproc: imx_rproc: add i.MX8QM/QXP
> >   remoteproc: imx_rproc: support i.MX7ULP
> >   remoteproc: imx_rproc: add i.MX8MM support
> >
> >  .../devicetree/bindings/remoteproc/imx-rproc.txt   |  33 --
> >  .../devicetree/bindings/remoteproc/imx-rproc.yaml  |  95 +++++
> >  drivers/remoteproc/imx_rproc.c                     | 455
> +++++++++++++++++++--
> >  drivers/remoteproc/remoteproc_core.c               |  19 +-
> >  include/linux/remoteproc.h                         |   1 +
> >  5 files changed, 531 insertions(+), 72 deletions(-)  delete mode
> > 100644 Documentation/devicetree/bindings/remoteproc/imx-rproc.txt
> >  create mode 100644
> > Documentation/devicetree/bindings/remoteproc/imx-rproc.yaml
> >
> > --
> > 2.16.4
> >
> >
> >
> 
> --
> Pengutronix e.K.                           |
> |
> Steuerwalder Str. 21                       |
> http://www.pengutronix.de/  |
> 31137 Hildesheim, Germany                  | Phone:
> +49-5121-206917-0    |
> Amtsgericht Hildesheim, HRA 2686           | Fax:
> +49-5121-206917-5555 |




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux