Add a description for the new fsl,inverted-tx and fsl,inverted-rx
options for the i.MX UART peripheral.
Signed-off-by: George Hilliard <ghilliard@xxxxxxxxxxxxxxx>
---
v1..v2: Removed confidentiality spam
Documentation/devicetree/bindings/serial/fsl-imx-uart.txt | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
index 35957cbf1571..c8d677f9491f 100644
--- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
+++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
@@ -8,6 +8,10 @@ Required properties:
Optional properties:
- fsl,dte-mode : Indicate the uart works in DTE mode. The uart works
in DCE mode by default.
+- fsl,inverted-tx , fsl,inverted-rx : Indicate that the hardware attached
+ to the peripheral inverts the signal transmitted or received,
+ respectively, and that the peripheral should invert its output/input
+ using the INVT/INVR registers.
- rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx,
linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485
you must enable either the "uart-has-rtscts" or the "rts-gpios"
--
2.25.0
