Darren Etheridge <detheridge@xxxxxx> wrote on Fri [2014-May-09 09:47:49 -0500]: > Tomi Valkeinen <tomi.valkeinen@xxxxxx> wrote on Fri [2014-May-09 14:29:02 +0300]: > > On 06/05/14 19:10, Tony Lindgren wrote: > > > * Darren Etheridge <detheridge@xxxxxx> [140422 13:39]: > > >> Add the necessary nodes to enable the LCD controller and the > > >> LCD panel that is attached to the Texas Instruments AM335x > > >> EVMSK platform. Also setup the necessary pin mux within the > > >> DT file to drive the LCD connector and add the correct > > >> pinmux settings for the lcd pins to be configured to when > > >> the SoC goes into sleep state for the minimum power > > >> consumption. > > >> > > >> For the sleep mode LCD pin settings, MUX_MODE7 is chosen as > > >> this corresponds to switching the pins into input GPIO's with > > >> an internal pulldown. Which has been determined to offer the > > >> lowest power solution vs leaving the pins configured in LCD > > >> mode. > > > > > > Probably best that Tomi queues all the panel .dts changes into > > > a separate immutable branch that I can merge too. > > > > This is not for OMAP DSS, but for the LCDC used in beaglebone, so there > > are no dependencies to any of my work. > > > > Benoit had always queued these LCDC dts patches in the past. This is > exactly the same as what had been done for AM335x-EVM and > AM335x-BeagleBone both of which are already in the mainline kernel. I > had just missed the EVMSK previously. > > Darren > There is a labeling mistake in this patch with the comments for LCD pins 16 through 23. I will correct it and send a V2. > > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
