* Tomi Valkeinen <tomi.valkeinen@xxxxxx> [140509 00:24]:
> On 09/05/14 02:33, Tony Lindgren wrote:
> > +Example when connected to a omap2+ based device:
> > +
> > + lcd0: display {
> > + compatible = "sharp,ls037v7dw01";
> > + power-supply = <&lcd_3v3>;
> > + enable-gpios = <&gpio5 24 GPIO_ACTIVE_HIGH>; /* gpio152, lcd INI */
> > + reset-gpios = <&gpio5 27 GPIO_ACTIVE_HIGH>; /* gpio155, lcd RESB */
> > + mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH /* gpio154, lcd MO */
> > + &gpio1 2 GPIO_ACTIVE_HIGH /* gpio2, lcd LR */
> > + &gpio1 3 GPIO_ACTIVE_HIGH>; /* gpio3, lcd UD */
> > +
> > + panel-timing {
> > + clock-frequency = <19200000>;
> > + hback-porch = <28>;
> > + hactive = <480>;
> > + hfront-porch = <1>;
> > + hsync-len = <2>;
> > + vback-porch = <1>;
> > + vactive = <640>;
> > + vfront-porch = <1>;
> > + vsync-len = <1>;
> > + hsync-active = <0>;
> > + vsync-active = <0>;
> > + de-active = <1>;
> > + pixelclk-active = <1>;
> > + };
>
> I don't think we should define panel-timing here. We know it's
> sharp,ls037v7dw01, so the driver knows the video timings. Also, if we
> would extend the driver to support both resolution modes, it needs to
> support two different timings, so the above doesn't work in that case
> either.
OK. It seems we can have at least two different timings for this panel,
the VGA timing above and the QVGA timings that LDP uses that are listed
in the .dts changes.
> Although if the MO gpio is not controlled by the driver, we should tell
> the driver whether that gpio is high or low.
What do you have in mind for telling that? We should also tell the
orientation of the panel:
EVM VGA omapfb.rotate=3
LDP QVGA omapfb.rotate=0
Do you have something in mind for that?
> At the moment our display drivers are OMAP specific, and for that reason
> we should prefix the compatible strings with "omapdss,". For example,
> drivers/video/fbdev/omap2/displays-new/panel-dsi-cm.c:
>
> { .compatible = "omapdss,panel-dsi-cm", },
>
> But we should still have the right compatible string in the .dts, so we
> convert the compatible name in arch/arm/mach-omap2/display.c, with
> 'dss_compat_conv_list' array, to which this panel's name should be added.
Oh so what do you want to have in the .dts file then?
Regards,
Tony
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
