From: Chen-Yu Tsai <wens@xxxxxxxx> The Cubieboard2 has CSI1 pins exposed on one of its GPIO headers. Combined with I2C1 on the same header, a connected OV7670 based camera module can be used. Power is provided via the 5V rail on the same header. The module has onboard LDOs for the sensor's various power rails. Add a device node for the sensor, enable CSI1 and I2C1, and hook everything up. Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx> --- arch/arm/boot/dts/sun7i-a20-cubieboard2.dts | 42 +++++++++++++++++++++ 1 file changed, 42 insertions(+) diff --git a/arch/arm/boot/dts/sun7i-a20-cubieboard2.dts b/arch/arm/boot/dts/sun7i-a20-cubieboard2.dts index b8203e4ef21c..0ff1593041eb 100644 --- a/arch/arm/boot/dts/sun7i-a20-cubieboard2.dts +++ b/arch/arm/boot/dts/sun7i-a20-cubieboard2.dts @@ -100,6 +100,25 @@ &cpu0 { cpu-supply = <®_dcdc2>; }; +&csi1 { + pinctrl-names = "default"; + pinctrl-0 = <&csi1_8bits_pg_pins>; + status = "okay"; + + port { + /* Parallel bus endpoint */ + csi_from_ov7670: endpoint { + remote-endpoint = <&ov7670_to_csi>; + bus-width = <8>; + /* driver is broken */ + hsync-active = <0>; /* Active high */ + vsync-active = <1>; /* Active high */ + data-active = <1>; /* Active high */ + pclk-sample = <1>; /* Rising */ + }; + }; +}; + &de { status = "okay"; }; @@ -142,6 +161,29 @@ axp209: pmic@34 { &i2c1 { status = "okay"; + + ov7670: camera@21 { + compatible = "ovti,ov7670"; + reg = <0x21>; + pinctrl-names = "default"; + pinctrl-0 = <&csi1_clk_pg_pin>; + clocks = <&ccu CLK_CSI1>; + clock-names = "xclk"; + + reset-gpios = <&pio 7 14 GPIO_ACTIVE_LOW>; /* PH14 */ + powerdown-gpios = <&pio 7 15 GPIO_ACTIVE_HIGH>; /* PH15 */ + + port { + ov7670_to_csi: endpoint { + remote-endpoint = <&csi_from_ov7670>; + bus-width = <8>; + hsync-active = <1>; /* Active high */ + vsync-active = <1>; /* Active high */ + data-active = <1>; /* Active high */ + pclk-sample = <1>; /* Rising */ + }; + }; + }; }; &ir0 { -- 2.24.1