On Tue, Dec 17, 2019 at 8:32 PM Chen-Yu Tsai <wens@xxxxxxxx> wrote:
>
> On Wed, Dec 18, 2019 at 12:22 PM Vasily Khoruzhick <anarsoul@xxxxxxxxx> wrote:
> >
> > From: Ondrej Jirman <megous@xxxxxxxxxx>
> >
> > There are two sensors, one for CPU, one for GPU.
> >
> > Signed-off-by: Ondrej Jirman <megous@xxxxxxxxxx>
> > Signed-off-by: Vasily Khoruzhick <anarsoul@xxxxxxxxx>
> > ---
> > arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi | 33 ++++++++++++++++++++
> > 1 file changed, 33 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
> > index 29824081b43b..cdcb1a36301a 100644
> > --- a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
> > +++ b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
> > @@ -11,6 +11,7 @@
> > #include <dt-bindings/reset/sun50i-h6-ccu.h>
> > #include <dt-bindings/reset/sun50i-h6-r-ccu.h>
> > #include <dt-bindings/reset/sun8i-de2.h>
> > +#include <dt-bindings/thermal/thermal.h>
> >
> > / {
> > interrupt-parent = <&gic>;
> > @@ -233,6 +234,12 @@ dma: dma-controller@3002000 {
> > sid: efuse@3006000 {
> > compatible = "allwinner,sun50i-h6-sid";
> > reg = <0x03006000 0x400>;
> > + #address-cells = <1>;
> > + #size-cells = <1>;
> > +
> > + ths_calibration: thermal-sensor-calibration@14 {
> > + reg = <0x14 0x6>;
>
> Nit: my preference is to use words as the smallest increment, so this
> would have a size of 8 instead of 6. Same goes for the A64 dts.
>
> AFAICT this doesn't impact the driver in any way.
H6 has only 2 sensors, so it should be 4. That's my overlook, I'll
change it to 4 for H6 and to 8 for A64.
>
> ChenYu
>
>
> > + };
> > };
> >
> > watchdog: watchdog@30090a0 {
> > @@ -856,5 +863,31 @@ r_i2c: i2c@7081400 {
> > #address-cells = <1>;
> > #size-cells = <0>;
> > };
> > +
> > + ths: thermal-sensor@5070400 {
> > + compatible = "allwinner,sun50i-h6-ths";
> > + reg = <0x05070400 0x100>;
> > + interrupts = <GIC_SPI 15 IRQ_TYPE_LEVEL_HIGH>;
> > + clocks = <&ccu CLK_BUS_THS>;
> > + clock-names = "bus";
> > + resets = <&ccu RST_BUS_THS>;
> > + nvmem-cells = <&ths_calibration>;
> > + nvmem-cell-names = "calibration";
> > + #thermal-sensor-cells = <1>;
> > + };
> > + };
> > +
> > + thermal-zones {
> > + cpu-thermal {
> > + polling-delay-passive = <0>;
> > + polling-delay = <0>;
> > + thermal-sensors = <&ths 0>;
> > + };
> > +
> > + gpu-thermal {
> > + polling-delay-passive = <0>;
> > + polling-delay = <0>;
> > + thermal-sensors = <&ths 1>;
> > + };
> > };
> > };
> > --
> > 2.24.1
> >
