On Thu, 2019-12-12 at 17:07 +0100, Marco Felsch wrote:
> Hi Sjoerd,
>
> On 19-12-12 17:02, Sjoerd Simons wrote:
> > Sabrelite boards can have an lvds screen attached with a built-in
> > i2c touch
> > screen. Enable this in the dtsi.
>
> Can this be any screen available on the market?
I guess i should have been more clear here; This is the touchscreen in
the hannstar display (already part of the dts) that was sold as an
accessoiry to the sabrelite.
Same as the screen that can be used on the boundary nitrogen6 boards
(which do have the touch part already enabled in the dts)
>
> > Signed-off-by: Sjoerd Simons <sjoerd.simons@xxxxxxxxxxxxxxx>
> > ---
> >
> > arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 8 ++++++++
> > 1 file changed, 8 insertions(+)
> >
> > diff --git a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
> > b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
> > index 8468216dae9b..382b127b2251 100644
> > --- a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
> > +++ b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
> > @@ -416,6 +416,14 @@ &i2c3 {
> > pinctrl-names = "default";
> > pinctrl-0 = <&pinctrl_i2c3>;
> > status = "okay";
> > +
> > + touchscreen@4 {
> > + compatible = "eeti,egalax_ts";
> > + reg = <0x04>;
> > + interrupt-parent = <&gpio1>;
> > + interrupts = <9 IRQ_TYPE_EDGE_FALLING>;
> > + wakeup-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
>
> The wakeup-gpio and the irq-line are sharing the same gpio line?
>
> Regards,
> Marco
>
> > + };
> > };
> >
> > &iomuxc {
> > --
> > 2.24.0
> >
> >
> >
--
Sjoerd Simons
Collabora Ltd.
